Verdiem Surveyor 6 Administrator Guide

Verdiem Surveyor 6 Administrator GuideStep8TaskWhen you are ready to start enforcing powermanagement settings on devices, assignpolicies to devices manually or throughassignment rules.Begin policy enforcement by changing thedevice policy from Baseline Data Collectionto another policy that enforces powermanagement settings.Descriptionon page 96, and Create and edit power statetransition rules on page 99.To assign policies to devices manually:1. In the Administrator console, on theVerdiem menu , click Devices, andthen click a group to view the devicesassigned to that group.Or, in the Administrator console, click theSearch button and filter the deviceview.2. Select a device or set of devices.3. Right-click a device (or a multi-selectedset of devices), and then click ManuallyAssign Policy.For more details, see Assign policies todevices on page 66.To assign policies to devicesautomatically:In the Administrator console, on theConfigure menu , click Auto PolicyAssignment Rules.For details, see Configure policy assignmentrules on page 90.9Review reports on user and device activityto fine tune group and policy assignment.IMPORTANT: To view data forreports, you must first run thesummarization process. For details,see Configuring and running the datasummarization process in the Surveyor6 Installation Guide.In the Administrator console, on the Verdiemmenu , click Computer State/ActivityReport or Device Events Report.For details, see View the ComputerState/Activity report on page 138 and Viewthe Device Events report on page 141.Introduction to Surveyor 617