Ethernet Protocol of VZ-9, VZ-9plus, VZ-27plus, VZ ... - WolfVision

More documents

Recommendations

Info

Focus ControlFocus ControlDec.- Command Description NotesCode194 Focus far By sending this command the Visualizer focuses towards far.For continuous changing the focus, send this code repetitively(min. 10Hz) as long as you want to change the focus.198 Focus near By sending this command the Visualizer focuses towards near.For continuous changing the focus, send this code repetitively(min. 10Hz) as long as you want to change the focus.131 Start Focus far This command starts to focus towards far. The Visualizerchanges the focus until the „Stop Zoom/Focus/Iris“-command ora different Start-Command is received (or the mechanical endpositionis reached).132 Start Focus near This command starts to focus towards near. The Visualizerchanges the focus until the „Stop Zoom/Focus/Iris“-command ora differentStart-Command is received (or the mechanical end-position isreached).128 StopZoom/Focus/Iris249 One-PushAuto FocusThis command stops zooming, focusing, iris and mirrormovement(if activated with the respective „Start xxx“-commandbefore).By sending this command the Visualizer performs a one-pushauto focus.1, 3239 Autofocus-ON Switches the Auto Focus on. 5240 Autofocus-OFF Switches the Auto Focus off. 531 AutofocusON/OFFSwitches the Auto Focus on/off 6T-06-02.Ethernet Protocol VZ-9_27plus_57plus_C11_C12_C30_C32.doc Page 4
Iris ControlIris ControlDec.-Code193 Iris open /Brightness upCommand Description Notes197 Iris close /Brightness downBy sending this command the Visualizer opens the iris. Forcontinuous opening the iris, send this code repetitively (min.10Hz) as long as you want to open iris.By sending this command the Visualizer closes the iris. Forcontinuous closing the iris, send this code repetitively (min.10Hz) as long as you want to close iris.133 Start Iris open This command starts to open the iris. The Visualizer opens theiris until the „Stop Zoom/Focus/Iris“-command or a differentStart-Command is received (or the mechanical end-position isreached).134 Start Iris close This command starts to close the iris. The Visualizer closes theiris until the „Stop Zoom/Focus/Iris“-command or a differentStart-Command is received (or the mechanical end-position isreached).128 StopZoom/Focus/IrisThis command stops zooming, focusing, iris and mirrormovement(if activated with the respective „Start xxx“-commandbefore).167 Auto Iris on Switches the Auto Iris on.168 Auto Iris off Switches the Auto Iris off. 47, 87, 87, 87, 8T-06-02.Ethernet Protocol VZ-9_27plus_57plus_C11_C12_C30_C32.doc Page 5
Page 2 and 3: TECHNICAL INFORMATIONWOLF VISION Gm
Page 6 and 7: Telescope Arm ControlTelescope Arm
Page 8 and 9: Light On/Off ControlLight On/Off Co
Page 10 and 11: Visualizer Menu, Camera ControlVisu
Page 12 and 13: Image Turn CommandsImage Turn Comma
Page 14 and 15: Output Resolution CommandsOutput Re
Page 16 and 17: Image Storing CommandsImage Storing
Page 18: NotesNotes1. Zooming switches on Au

Ethernet Protocol of VZ-9, VZ-9plus, VZ-27plus, VZ ... - WolfVision

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?