Balancer Diagnostic Codes - Snap-on Equipment

- the motor power supply is not configured properly- there is a fault in the motor power supply board- there is a fault in the rear scanner motor- there is a fault in the camera controller board motor drivers- the cable connecting the camera controller board and the rear scanner motor ispartially unplugged or damagedCorrective actions:- check all items above24.8 Check Optima rear laser power supply E397Affected models : Models with optima hardwareService <strong>Codes</strong> : C123Possible causes: -the flat cable connecting the camera controller board and the rear scanner CCDboard is unplugged, missing or damaged- the cable of the laser module of the rear scanner is damaged or there is a fault inthe laser module itself- there is a fault in the camera controller board laser driversCorrective actions:- check all items above24.9 Check Optima rear laser modulation E398Affected models : Models with optima hardwareService <strong>Codes</strong> : C123Possible causes: -the flat cable connecting the camera controller board and the rear scanner CCDboard is unplugged, missing or damaged- the cable of the laser module of the rear scanner is damaged or there is a fault inthe laser module itself- there is a fault in the camera controller board laser driversCorrective actions:- check all items above25.1 Check Optima rear shift motor power supply E404Affected models : Models with optima hardwareService <strong>Codes</strong> : C123Possible causes: -the cable connecting the camera controller board and the rear shift scanner motoris unplugged, damaged or missing- the motor power supply is not configured properly- there is a fault in the motor power supply board- the cable connecting the mains supply and the motor power supply board is unplugged,damaged or missing- there is a fault in the rear shift scanner motor- there is a fault in the camera controller board motor driversCorrective actions:- check all items above25.2 Check Optima rear shift scanner zero mark E405Affected models : Models with optima hardwareService <strong>Codes</strong> : C123Possible causes: -the flat cable connecting the camera controller board and the rear shift scannerCCD board is unplugged, missing or damaged- there is a fault in the rear shift scanner CCD boardCopyright © 2007 <strong>Snap</strong>-on Equipment Services. All Rights Reserved 11