Balancer Diagnostic Codes - Snap-on Equipment

Corrective actions:-check all items above22.7 Check Optima inner motor missing steps E376Affected models : Models with optima hardwareService <strong>Codes</strong> : C123Possible causes: - the inner scanner movement is not smooth or it is striking the frame- the motor power supply is not configured properly- there is a fault in the motor power supply board§ there is a fault in the inner scannermotor- there is a fault in the camera controller board motor drivers- the cable connecting the camera controller board and the inner scanner motor ispartially unplugged or damagedCorrective actions:- check all items above22.8 Check Optima inner laser power E377Affected models : Models with optima hardwareService <strong>Codes</strong> : C123Possible causes: -the flat cable connecting the camera controller board and the inner scanner CCDboard is unplugged, missing or damaged- the cable of the laser module of the inner scanner is damaged or there is a faultin the laser module itself- there is a fault in the camera controller board laser driversCorrective actions:- check all items above22.9 Check Optima inner laser modulation E378Affected models : Models with optima hardwareService <strong>Codes</strong> : C123Possible causes: -the flat cable connecting the camera controller board and the inner scanner CCDboard is unplugged, missing or damaged- the cable of the laser module of the inner scanner is damaged or there is a faultin the laser module itself- there is a fault in the camera controller board laser driversCorrective actions:- check all items above23.1 Check Optima outer CCD signals E380Affected models : Models with optima hardwareService <strong>Codes</strong> : C123Possible causes: -the flat cable connecting the camera controller board and the outer scanner CCDboard is unplugged, missing or damaged- there is a fault in the outer scanner CCD board § there is a fault in the cameracontroller board- the supply voltage is configured too high on the power interface boardCorrectiveactions:- check all items above- switch power off and on again; should the problem not go away please call service23.2 Check Optima outer scanner memory E381Affected models : Models with optima hardwareService <strong>Codes</strong> : C123Possible causes: -the flat cable connecting the camera controller board and the outer scanner CCDboard is unplugged, missing or damaged- there is a fault in the outer scanner CCD board- there is a fault in the camera controller boardCorrective actions:- check the connections§ check the outer scanner CCD boardCopyright © 2007 <strong>Snap</strong>-on Equipment Services. All Rights Reserved 7