product manual for Intex Round Above Ground Pool Sand ... - Meijer

Meijer.com(163) MODEL CS15110 SAND FILTER PUMP & FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 11/08/2011English163SETUP INSTRUCTIONS (continued)Sand loading:IMPORTANT: Use No. 20 silica sand or glass sand with particle size range0.45 to 0.85 mm (0.018 to 0.033 inches) and a Uniformity Coefficient lessthan 1.75.NOTE: Before loading the tank with sand, ensure the center pipe hubassembly is securely in place at the bottom of the tank, and verticallycentered inside the tank.1. Place the sand shield (7) over the top of the center pipe. Pour the sand into thetank at a slow rate. (see drawing 15).2. Fill the tank approximately half way, remove the sand shield (7). (seedrawing 16).15 1673. Evenly distribute the sand inside the tank, then fill the tank with some water toprovide a cushioning effect when the remaining sand is poured in. Thisprevents the center pipe hub (8) from excessive shock (see drawing 17).Place the sand shield (7) back and continue to pour the sand into the tank.4. Sand shall be filled between the “MAX” and “MIN” marked gauge on the centerpipe. Evenly spread and level out the sand by hand (see drawings 17 & 18).8717 18SETUP INSTRUCTIONSMAXMIN8MAXMAXMINMAXMIN5. Remove the sand shield (7).6. Wash away all sand around the top edge of the tank.SAVE THESE INSTRUCTIONS Page 13