product manual for Intex Round Above Ground Pool Sand ... - Meijer

Meijer.com(163) MODEL CS15110 SAND FILTER PUMP & FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 11/08/2011English163TROUBLESHOOTING GUIDE (continued)PROBLEM CAUSE SOLUTIONINSUFFICIENTCHLORINEINSUFFICIENTCOPPER IONLEVELPOOL IS STAINEDWHITE FLAKES INTHE WATERNO LED DISPLAYGREEN HAIR• Without cyanuric acid.• Insufficient operating hours ofthe Saltwater System.• The salt level in the pool wateris less than 2000ppm. This isinsufficient.• Chlorine loss due to intensesunlight exposure.• The bather load has increased.• Clogged or dirty electrolytic cell.• Insufficient operating hours.• The PH is too high.• The bather load has increased.• Clogged or dirty electrolytic cell.• Copper electrode defective.• High copper ion concentration.• Excessive calcium hardness ispresent in pool water.• No power supply.• RCD/GFCI has not reseted.• A power fuse has blown.• LED failure.• High copper ion concentration.• See “Cyanuric acid table”.• Increase the daily Saltwater Systemoperating time. See “Operating Instructions”.• Check the salt level with the Test Kit. Adjustas needed. See “Salt & Pool Water Volumes”.• Use a pool cover when the pool is not in useand/or when the unit is operating.• Increase the daily Saltwater System operatingtime. See “Operating Instructions”.• Remove the cell for inspection, clean it ifnecessary. See “Maintenance”.• Increase operating time per day. See“Operating Instructions”.• Use PH decrease chemical to adjust,contact your local pool chemical store.• Increase the operating time per day.See “Operating Instructions”.• Remove the cell for inspection, clean itif necessary. See “Maintenance”.• Contact Intex Service Center.• Drain about 20% of the pool water and addfresh water to decrease the copper ionconcentration below 0.2ppm.• Add aluminum sulfate: 1000 liters water needaround 2g (1000 gals need 0.27 ounce) oraluminum potassium sulfate: 1000 liters waterneed around 3g (1000 gals need 0.4 ounce)to pool.• Use a lemon based cleaning product(preferably containing citric acid). Don’t scrubwith aggressive cleaning products becausethis might etch the underlying surface.• Drain about 20 to 25% of the poolwater and add fresh water to decreasethe calcium hardness. Inspect theelectrolytic cell for scale buildup. Cleanthe electrolytic cell if necessary.• Plug the cell cord firmly into the cellhousing receptacle.• Reset the RCD/GFCI.• Contact Intex Service Center.• Contact Intex Service Center.• Drain about 20% of the pool water andadd fresh water to decrease the copperion concentration below 0.2ppm.• Add aluminum sulfate: 1000 literswater need around 2g (1000 gals need0.27 ounce) or aluminum potassiumsulfate: 1000 liters water need around3g (1000 gals need 0.4 ounce) to pool.• Use ‘Ultra-Swim’ shampoo, or shampoocontaining chelating agents.TROUBLESHOOTING GUIDESAVE THESE INSTRUCTIONS Page 34