product manual for Intex Round Above Ground Pool Sand ... - Meijer

Meijer.com(163) MODEL CS15110 SAND FILTER PUMP & FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 11/08/2011English163MOTOR PRE-FILTER CLEANING AND MAINTENANCE1. Make sure the filter pump is switched off, then disconnect the power cord fromthe electrical outlet.2. Grasp a plunger valve handle. Turn the handle counter-clockwise, push downuntil it stops and then turn it clockwise until the plastic protruding notch anchorsin the "0/1" position. Repeat for the second plunger valve. This prevents thewater from flowing out of the pool.3. Release the pressure first by opening the34sediment release valve (19) locatedon the lower side of the pre-filter housing(see drawing 34).4. In a counter-clockwise motion unscrew the19leaf trap cover (14), then remove thebasket (16) and leaf trap o-ring (15) from the2pre-filter housing (see drawing 35).15. Empty and flush the basket using a gardenhose, may use a plastic brush to removedeposits from the basket. Do not use metal 1435brush.41156. Clean and rinse the inside of the pre-filterhousing and the leaf trap O-ring with16a garden hose.7. Reinstall the leaf trap O-ring, basket and leaftrap cover to the pre-filter housing.8. Close the sediment release valve (19) back.MAINTENANCEFLOW SENSOR CLEANING1. In a counter-clockwise motion unscrew the collar of the flow sensor (21)and remove it from the electrolytic cell conduit (22). See “Part Reference”.2. If deposits and debris are seen on the surface of the flow sensor, then usea garden hose to wash it off.HingeLocator NotchConnection Ridge3. If flushing with water does not remove the deposits, use a plastic brush toclean the surface and the hinge if necessary. Do not use a metal brush.4. After the flow sensor has been inspected and cleaned, align the locatornotch on the flow sensor to the connection ridge in the conduit. Now turnthe collar in a clockwise motion, tightening the sensor back into its position.Do not overtighten.SAVE THESE INSTRUCTIONS Page 28