12.07.2015 Views

VICE &PROTÉGÉ MANUAL VERSION 2.0 - Bob Long Technologies

VICE &PROTÉGÉ MANUAL VERSION 2.0 - Bob Long Technologies

VICE &PROTÉGÉ MANUAL VERSION 2.0 - Bob Long Technologies

SHOW MORE
SHOW LESS
  • No tags were found...

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

MAINTAINING THE HPRYour Vice comes equipped with the best regulators on the market. To ensure the best consistency and the highestflow possible, it is recommended that you clean and grease the in line regulator (HPR) according to themaintenance schedule.1. Degas the marker and ensure that there are nopaintballs in the breech or barrel of the marker.2. Remove your macroline hose from the 90˚fitting on your regulator. Push up on the hosethen hold the silver ring while pulling the hosedown.3. Unscrew the regulator from the verticaladaptor, and set your marker down.4. Grasp the two halves of the regulator, andunscrew the regulator base counter clockwise.5. Reach into the regulator base with tweezers orneedle nose pliers to remove the regulatorpiston.6. The main valve does not need to be removedfrom the upper portion of the regulator. Neverreplace or attempt to service a working mainvalve.7. Inspect the surface of the piston and piston o-ring for excessive wear or nicks, and replace asnecessary.8. Inspect the interior walls of the regulator base—if necessary, use a swab on the interior of theregulator base to clean debris and old grease.9. When reassembling the spring follower (springstack assembly) make sure that the top andbottom spring washers curve to the outside. Aclose up of the spring assembly with theretaining o-ring is shown to the right. Theretaining o-ring does not require lubricationIf in doubt – just stack the spring washers likethis:)()()()(10. Grease the piston o-ring with and gently replacethe spring follower (spring stack assembly) andpiston into the regulator base. There is aconcave area around the o-ring that holdsadditional lube and reduces the need forfrequent maintenance. Reassemble theregulator to the marker. Make sure theregulator body halves and the regulator itselfare snugly screwed together.1 23 45 67 89 10CAUTION: READ ALL WARNINGS BEFORE USING OR ATTEMPTING ANY WORK ON YOUR <strong>VICE</strong>.SHOULD YOU BE UNSURE AT ANY POINT, STOP AND SEEK PROFESSIONAL SUPPORT.

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!