DTC C0210/33 RIGHT REAR SPEED SENSOR ... - Highlander Club

05-798DIAGNOSTICS-ABS WITH EBD & BA & TRAC & VSC SYSTEM21R142054WD:(a) Disconnect the rear speed sensor connector.(b) Measure the resistance according to the value(s) in thetable below.Standard:(c)Tester ConnectionSpecified Condition1 - 2 0.9 to 1.3 kΩ at 25 CMeasure the resistance according to the value(s) in thetable below.Standard:Tester ConnectionSpecified Condition1 - Body ground 10 kΩ or higher2 - Body ground 10 kΩ or higherNOTICE:Check the speed sensor signal after replacement(see page 05-765 ).NGREPLACE REAR SPEED SENSOR(SEE PAGE 32-37 )OK4 CHECK HARNESS AND CONNECTOR(REAR SPEED SENSOR - SKID CONTROLECU)Skid Control ECU S27(harness side connector)RR+ RL-RR- RL+Skid Control Sensor(harness side connector)A24A25(a)(b)Disconnect the skid control ECU connector and the skidcontrol sensor connector.Measure the resistance according to the value(s) in thetable below.Standard:LH:Tester ConnectionSpecified ConditionS27-20 (RL+) - A24-1 (RL+) Below 1 ΩS27-6 (RL-) - A24-2 (RL-) Below 1 ΩRH:Tester ConnectionSpecified ConditionS27-5 (RR+) - A25-1 (RR+) Below 1 ΩRL-RL+RR-RR+G26241(c)S27-19 (RR-) - A25-2 (RR-) Below 1 ΩMeasure the resistance according to the value(s) in thetable below.Standard:LH:Tester ConnectionSpecified ConditionS27-20 (RL+) - Body ground 10 kΩ or higherS27-6 (RL-) - Body ground 10 kΩ or higherRH:Tester ConnectionSpecified ConditionS27-5 (RR+) - Body ground 10 kΩ or higherS27-19 (RR-) - Body ground 10 kΩ or higherAuthor:Date:988