AIR VENT MANIFOLD - Claymore Paintball

INSTALLATION INSTRUCTIONS[ PLEASE READ CAREFULLY ]01 02 03 040506Remove the grip framefrom the Shockerbody. (Refer to thedisassembly section inyour Shocker owner’smanual–an additionalhex wrench will berequired.)Take a good look atthe solenoid valve, andthe manifold plate onwhich it is mounted.The Air Vent Manifoldwill be installed in thesame position as theoriginal manifold plate.If your Shocker SFT isequipped with a VisionEye, carefully unplugthe Vision flex stripfrom the upper circuitboard (the circuit boardmounted on the solenoidvalve.)Unscrew both solenoidmounting screws usinga 1/16” Allen Wrench,and gently pull the solenoidvalve away fromthe body.Note the positions ofthe three round o-ringsin the stock manifoldplate. Insert the newo-rings in their correspondingpositions onthe Air Vent Manifold.Using the 1/16” AllenWrench, remove bothscrews that are holdingthe old manifold plateto the Shocker body.070809 10 11Note the positions ofthe one round and thetwo oblong o-ringsin the stock manifoldplate. Insert the newo-rings in their correspondingpositions onthe Air Vent Manifold.Save the old o-rings asspares.Install the new manifoldplate. The oval shaped o-ring grooves will face theShocker body. Make surethat the rounded side ofthe plate points towardsthe barrel end of themarker. Use firm pressure,but do not over-tightenthe manifold plate screws.Replace solenoid and screws using the 1/16” Allenwrench. Use only a gentle tightness on these screws.DO NOT OVERTIGHTEN THE SCREWS OR YOUWILL STRIP THE MANIFOLD PLATE.Reattach the Vision flexstrip with the metal contactsfacing away fromthe Shocker SFT body.Reassemble yourShocker.Be careful not tooverstress the solenoidmounting screws whenaligning the body andgrip frame, or to pinchthe wiring harnessinside the grip frame.800.922.2147 www.smartparts.com02