MainswitchSurfacemounting Partno. T5B-4-15682/I4 ... - LUCKINSlive

NotesNotesThe following applies for solid, multiwire, and flexible terminal capacities:If 2 conductors are being used, a max. difference of one cross-section category is permissibleThe following applies for part no. T8-3-8342/...: switching angle = 90° and flat terminal = 1 rail, 25 x 5, or 2 rails, 20 x 3TechnicaldataETIM4.0Version as switch disconnector compact NoVersion as main switch YesVersion as maintenance-/service switch YesVersion as safety switch NoVersion as emergency stop installation YesMax. rated operation voltage Ue AC V 690Rated permanent current Iu A 63Rated operation power AC-3, 400 V kW 22Rated operation power at AC-23, 400V kW 22Conditioned rated short-circuit current Iq kA 0Number of poles 6Number of auxiliary contacts as normally closed contact 1Number of auxiliary contacts as normally open contact 1Number of auxiliary contacts as change-over contact 0Motor drive optional NoMotor drive integrated NoVoltage release optional NoDevice construction Complete device in housingSuitable for ground mounting YesSuitable for front mounting NoSuitable for front mounting center NoSuitable for distribution board installation NoSuitable for intermediate mounting NoType of control element -Interlockable YesConnection type main current circuit Screw connectionDegree of protection (IP), front side IP65CharacteristicsFor utilisation category AC-4 (extreme load: 100 % inching, reversing or plugging)The blocked rotor current of the motor should not exceed the rated current of the switch for AC-21A to ensure a reasonable device lifespan.Dimensions04/23/2013 HPL-ED2013 V1.0 EN 4 / 5