TI110B1 GSM/PSTN Dual Network Burglar Alarm System

into “Arm Stay”. When some intruders enter those zones, the detectors in those zones cansend the alarm signal to the alarm panel and trigger alarm whistle. While those zoneswhere some stayers are in will be disarmed condition and will not send the alarm signalas though intruders enter into.a. Set zones into Arm StayDemonstration: set the 2 nd zone , and the zones from the 4 th to 16 th into Arm Stay while the 1 stand 3 rd ones are set into Arm AwayOperation steps: Press the key “ Zone ” key, and the screen displays PROG..Zone P artly ArmThen input0 2 0 4 0 5 0 6 0 7 0 8 0 9 1 0 1 1 1 2 1 3 1 4 1 5 1 6. Enter .The alarm panel sounds a long indicator voice to inform you that you have set the ArmStay successfullyb. Set zones into Arm AwayDemonstration 1: set the zones from 1 st to 12 th into Arm AwayPROG.Operation steps: Press the key “ Zone ” continuously, and the screen displaysZoneThen input .W holly Arm0 1 0 2 0 3 0 4 0 5 0 6 0 7 0 8 0 9 1 0 1 1 1 2Enter. The host sounds a long indicator voice to inform you that you have set the Arm Awaysuccessfully.Demonstration 2: set all the zones into Arm AwayPROG.Operation steps: press the key “ Zone ” key continuously, and the screen displays ZoneW holly Arm.Then press the key “ Enter ” directly. The alarm panel sounds a long indicator voice toinform you that you have set all the zones into Arm Away successfully.c. Set Emergency ZoneDemonstration: set the 9th and 10th zone into Emergency Zone PROG.DisarmOperation steps: press the key “ Zone ” repeat, and the screen displays Zone.Then input 0 9 1 0 . .The alarm panel sounds indicator voice. The “EmergencyZone” is 24-hour zone without controlling by the arm/disarm operation, so the zone statusshow “Disarm”Cancel “Emergency Zone”: press the “ Zone ” continously till the screen displays the“Emergency Zone” under the Disarm condition. Then then input 8 .The alarm panelsounds indicator voice to inform that you have cancelled the “Emergency Zone”d. Modify the Arm Stay/Arm Away/Emergency ZoneYou can use the above way to reset the zones, and the new setting will automatically cover theformer zones. And the setting is subject to the latest one.www.best-china-security-supplies.com6. Set the alarm type (Note: each zone should be input with two-digital number. If not,please add “0” ahead)(1) There are seven alarm types available (Perimeter, Robbery, Steal, Emergency, Smoke/Gas and8