Gunnebo Classic Product Catalog

More documents

Recommendations

Info

INFORM A RIGGER - PASS THE WORD• Never use a worn-out or damaged sling.“Each day before being used, the sling and all fasteningsand attachments shall be inspected for damage ordefects by a competent person designated by theemployer. Additional inspections shall be performedduring sling use where service conditions warrant.Damaged or defective slings shall be immediatelyremoved from service” - OSHA 1910.184 (d).lapped shall be removed from service and shall not bereturned to service unless properly repaired.Hook latch, when required, shall be fully functionaland properly seated.“In addition to the inspection required by paragraph1910.184 (d), a thorough periodic inspection shall bemade on a regular basis, to be determined on the basisof (A) frequency of sling use; (B) severity of serviceconditions; (C) nature of lifts being made; and (D)experience gained on the service life of slings usedin similar circumstances. Such inspections shall inno event be at intervals greater than once every 12months.” - OSHA 1910.184 (e) (3) (i).“The thorough inspection of alloy steel chain slingsshall be performed by a competent person designatedby the employer, and shall include a thoroughinspection for wear, defective welds, deformation andincrease in length. Where such defects or deteriorationare present, the sling shall be immediately removedfrom service.” – OSHA 1910.184 (e) (3) (iii)“Worn or damaged alloy steel chain slings orattachments shall not be used until repaired.” – OSHA1910.184 (e) (7) (i).Chain sling with reach longer than given onidentification tag shall be immediately removed fromservice and evaluated for wear and material stretch.Chain link wear is limited by minimum cross-sectionaldimesions given in TABLE 6. Chain worn below thegiven limits shall be removed from service.Chain Sling connector or attachment with wear greaterthan 10 percent of the original dimension for anycross-section shall be removed from service.Chain sling coupler, chain, G-link, master ring, sublink,hook or attachment that is broken, cracked, bent,stretched or twisted shall be removed from service andshall not be repaired.• Never use a sling in extreme temperatures.“...alloy steel chain slings shall be permanentlyremoved from service if they are heated above1000°F...” - OSHA 1910.184 (e) (6).Alloy steel chain slings shall not be used while heatedabove 1000°F or cooled below -40°F.Alloy steel chain sling Working Load Limits (WLL)given in TABLE 1A or 1B are valid betweentemperatures of -40°F and 400°F.Alloy steel chain sling WLL shall be reduced inaccordance with TABLE 7A and 7B when heatedbetween 400°F and 1000°F.Permanent WLL reduction shall be made in accordancewith TABLE 7A and 7B for chain slings heatedover temperatures indicated. Identification tag shallbe replaced and the new tag shall have the reducedWLL.Chain sling with a coupler, chain, G-link, master ring,sub-link, hook or attachment nicked or gouged or30
INFORM A RIGGER - PASS THE WORD• Never use a sling in alkaline or acidic conditions.<strong>Gunnebo</strong> Lifting Grade 80 & Grade 100 alloy steelchain and components shall not be used in alkaline oracidic conditions. Resulting metal embrittlement andaccelerated corrosion can cause sudden sling failure.Hot dip galvanizing and electro-zinc plating of alloysteel chain and components shall be done only by<strong>Gunnebo</strong> Lifting.31
Page 3 and 4: All chain and every single componen
Page 5 and 6: Heavy dutylatch.Bushing allowshook
Page 9 and 10: For use with BLCoupler to formchoke
Page 11 and 12: Latch closesautomaticallyunder load
Page 13 and 14: The releasetrigger willonly operate
Page 15 and 16: Extra width (B)inside allowsbetter
Page 17 and 18: Engineered flateliminates mix ormat
Page 19 and 20: Forged Grade80 Alloy SteelHeat numb
Page 21 and 22: Coupling Pin/lockwasher set, GRADE
Page 23 and 24: Spare PartsLatch kit for oknStockNu
Page 25 and 26: DOSDOG DOF DOBKDOO BS ADOS DOLKTOS
Page 27 and 28: Tips for Chain Sling Assembly1. Sin
Page 29: INFORM A RIGGER - PASS THE WORD“H
Page 35 and 36: “It shall be determined that the
Page 38 and 39: INFORM A RIGGER - PASS THE WORDHook
Page 40: PORTLANDBRAMPTONCHICAGOWESTSPRINGFI

Gunnebo Classic Product Catalog

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?