R116 Heavy Duty Dense Graded Asphalt - Aapaq.org

(RMS COPYRIGHT AND USE OF THIS DOCUMENT - Refer to the Foreword after the Table of Contents)Heavy Duty Dense Graded AsphaltR116Table R116/B.1 – Deductions for Combined Particle Size Distribution and Binder ContentCombined Particle SizeDistribution Element% by which nonconformity exceedsproduction tolerance (Clause 2.4.2)(% by mass of total aggregate)Deductions(in per cent ofschedule rate)Pass 37.5 mm AS sieve Each 2 or part thereof 1Pass 26.5 mm AS sieve Each 2 or part thereof 1Pass 19.0 mm AS sieve Each 2 or part thereof 1Pass 13.2 mm AS sieve Each 2 or part thereof 1Pass 9.50 mm AS sieve Each 2 or part thereof 1Pass 6.70 mm AS sieve Each 2 or part thereof 1Pass 4.75 mm AS sieve Each 2 or part thereof 1Pass 2.36 mm AS sieve Each 1 or part thereof 1Pass 1.18 mm AS sieve Each 1 or part thereof 1Pass 0.600 mm AS sieve Each 1 or part thereof 1Pass 0.300 mm AS sieve Each 1 or part thereof 2Pass 0.150 mm AS sieve Each 0.5 or part thereof 2Pass 0.075 mm AS sieve Each 0.5 or part thereof 2Binder Content for(% by mass of total asphalt mix)20 mm asphalt or smaller Each 0.1 or part thereof 328 mm and 40 mm asphalt Each 0.1 or part thereof 2B2.2.2Insitu Air VoidsDeductions in accordance with Table R116/B.2 will be applied to accepted nonconformities inexcess of the upper characteristic insitu air voids provided that nonconformities will not beaccepted when the upper characteristic insitu air voids exceeds the specified limit by more than1.5%.Table R116/B.2 – Deductions for Nonconforming Insitu Air VoidsInsitu air voids is outside ofspecified limit V U byDeduction (in per centof value of Lot)< 0.5% 5%0.5% – 1.0% 30%1.1% – 1.5% 50%> 1.5% RejectEd 8 / Rev 3 29