R116 Heavy Duty Dense Graded Asphalt - Aapaq.org

More documents

Recommendations

Info

(RMS COPYRIGHT AND USE OF THIS DOCUMENT - Refer to the Foreword after the Table of Contents)R116Heavy Duty Dense Graded AsphaltClause5.1, 5.2 &5.3Planning DocumentsInspection and test plan, including methods and frequencies of sampling, methods andfrequencies of testing, verification checklists, and timeframe for submission of test results.34 Ed 8 / Rev 3
(RMS COPYRIGHT AND USE OF THIS DOCUMENT - Refer to the Foreword after the Table of Contents)Heavy Duty Dense Graded AsphaltR116ANNEXURE R116/E – CALCULATIONSE1CALCULATION OF CHARACTERISTIC VALUES OF INSITU AIR VOIDSRound and report the values of V U and V L to the nearest 0.1%.Calculate the upper (V U ) and lower (V L ) characteristic values of insitu air voids of the Lot as follows:V U = a + kswhere:V L = a – kss = the standard deviation of sub-Lot air voids expressed as a percentagek = value stated in RMS Q Annexure Q/L Clause L3.2a = the arithmetic mean of insitu air voids expressed as a percentage for all sub-Lotsand MD BD a 100% MD MD = mean maximum density of the Lot determined in accordance with AS2891.7.1or AS2891.7.3BD = bulk density of the sub-Lot determined in accordance with(i) AS2891.9.2 for cores(ii) AS 2891.14.2 and AS 2891.14.3 for nuclear density gaugeRound and report the values of V U and V L to the nearest 0.1%.E2CALCULATION OF CHARACTERISTIC VALUE OF THICKNESSCalculate the upper (T U ) and lower (T L ) characteristic values of thickness for the Lot as follows:T U = x + ks T L = x – kswhere: s = the standard deviation of sub-Lot attribute test resultsk = value stated in RMS Q Annexure Q/L Clause L3.2x = the average height of a core (mm) based on measurements taken at four equidistantpoints at the circumference of the core.x = the arithmetic mean of attribute test results for all sub-Lots(Note: x , x and s are in mm and T is rounded to the nearest whole millimetre.)Ed 8 / Rev 3 35
Page 1 and 2: ROADS AND MARITIME SERVICES (RMS)QA
Page 3 and 4: Ed/RevNumberClauseNumberDescription
Page 5: QA SPECIFICATION R116HEAVY DUTYDENS
Page 8 and 9: R116Heavy Duty Dense Graded Asphalt
Page 11 and 12: (RMS COPYRIGHT AND USE OF THIS DOCU
Page 43: (RMS COPYRIGHT AND USE OF THIS DOCU
Page 51: (RMS COPYRIGHT AND USE OF THIS DOCU

R116 Heavy Duty Dense Graded Asphalt - Aapaq.org

Create successful ePaper yourself

Delete template?

Save as template?