R116 Heavy Duty Dense Graded Asphalt - Aapaq.org

(RMS COPYRIGHT AND USE OF THIS DOCUMENT - Refer to the Foreword after the Table of Contents)Heavy Duty Dense Graded AsphaltR116ANNEXURE R116/D – PLANNING DOCUMENTSRefer to Clause 1.3.4. The following documents are a summary of documents that must be included inthe PROJECT QUALITY PLAN. Review the requirements of this Specification and others includedin the Contract to determine additional documentation requirements.Clause1.3.4 Manufacturer’s written recommendations.Planning Documents2.1 For each constituent material, Lot/stockpile sizes, method of defining each Lot andallocating a unique Lot Number.Procurement, handling and storage of each constituent material.Nominated particle size distribution and tolerances for each constituent aggregate.2.3 Development and authorisation of the nominated mix submission.2.4 For each nominated mix, method of defining each Lot and allocating a unique LotNumber.Calibration of the asphalt manufacturing plant, including all weigh scales, flowmeters andthermometers.Process control, including plant operating instructions, key temperature targets andrecords, and response to process control charts.Acquisition, storage and handling of binder, including identification and prevention ofsegregation and/or contamination.Control of plant feed proportions, including regular checks on grading and moisturecontent.Daily asphalt manufacturing plan to ensure timely and uninterrupted progress on site.2.5 Loading, delivery and unloading procedures that maintain adequate mix temperature anddo not interrupt progress of the paving train.3 For each paving and related activity, method of defining each Lot and allocating a uniqueLot Number.Calibration of all thermometers and other measuring equipment.Process control for surface preparation, tackcoating, placing, joint construction,compaction and cleanup, including plant operating instructions, key temperature targetsand records, patterns for paving and compaction operations, and process monitoring.3.3 Allocation of appropriate plant and equipment, including backup in case of breakdown.Rolling pattern, including roller type and number of passes3.6 Nominated layer thicknesses where these have not been specified by the Principal.3.7 Measurement and recording of pavement temperatures and weather conditions.3.8 Paving and compaction temperature3.10 Construction joints3.11 Design, execution and quality verification of a placement trial.4.2.1 Requirements for course thicknessEd 8 / Rev 3 33