12.07.2015 Views

ARB 4x4 ACCESSORIES - CARiD.com

ARB 4x4 ACCESSORIES - CARiD.com

ARB 4x4 ACCESSORIES - CARiD.com

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

10. Scotch lock the red wire inbetween the fog light loom makingsure the colour code matches.11. When all wiring is <strong>com</strong>pleted.Refit headlights back into vehicle.12. Next step is to cut grilleretainer panel so bar can be fitted.13. From the photo below markout a parallel line of 45mm andcut off panel not required using ajig saw or a key hole saw, thenrefit back to vehicle.REFER TO PARAGRAPH 2 FORPANEL IDENTIFICATIONPHOTO OF REFITTED PANEL OFLEFT CORNER OF VEHICLE14. Fit M10 caged nuts intochannel ( channels are L/RHS )then fit channels inside of chassisrailsNotch in channel must face inwardLast Rev Date: 19/04/06 Page 7 of 22 Fitting instructions# 3783216Copyright © 2005 by <strong>ARB</strong> Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of <strong>ARB</strong> Corporation Ltd

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!