USB HID Swipe Reader, Technical Reference Manual - MagTek

USB HID Swipe Readercard data transfer rate decreases the USB bus bandwidth used by the device.The value of this property will be sent to the host when the host requests thedevice’s USB endpoint descriptor.This property is stored in non-volatile memory, so it will persist when the unitis power cycled. When this property is changed, the unit must be reset (seeCommand Number 2) or power cycled to have these changes take effect.Example Set MAX PACKET SIZE property Request (Hex):Cmd Num Data Len Prp ID Prp Value01 02 03 08Example Set MAX PACKET SIZE property Response (Hex):Result Code Data Len Data00 00Example Get MAX PACKET SIZE property Request (Hex):Cmd Num Data Len Prp ID00 01 03Example Get MAX PACKET SIZE property Response (Hex):Result Code Data Len Prp Value00 01 08TRACK ID ENABLE PROPERTYProperty ID: 0x04Property Type: ByteLength: 1 byteGet Property: YesSet Property: YesDefault Value: 95 (hex)Description: This property is defined as follows:id 0 T 3 T 3 T 2 T 2 T 1 T 1IdT #0 – Decodes standard ISO/ABA cards only1 – Decodes AAMV and 7-bit cards also00 – Track Disabled01 – Track Enabled10 – Track Enabled/Required (Error if blank)This property is stored in non-volatile memory, so it will persist when the unit ispower cycled. When this property is changed, the unit must be reset (seeCommand Number 2) or power cycled to have these changes take effect.22