Manual - Gates

More documents

Recommendations

Info

CONNECTING THE CHAINFRONT INSTALLATIONWeld front bracket with gate in open position.Weld rear bracket with gate in closed position.REAR INSTALLATION – COVER MODIFICATIONCut the cover 17 1/2 inches high. (See below)Make sure the idler wheel has a safety cover.Important: For safe operation of the gateopener do not cut the slots any wider orlonger than shown. DO NOT modify thehousing in any way other than specified.17.5"Cut the chain access slot on the one sideof the cover to the exact specifications.2"13
CONCRETE PAD AND GATE ATTACHMENTTop Inside View8.25"13"Follow gatemanufacturersspecificationsand localbuilding codesfor setting post.Conduit Area WithoutBattery Back-UpAboveGround6"12"10"12"BelowGround 24" 24"8"Suggested installation for dirtground. The measurementsdepend on the type of ground(ie., asphalt, cement, dirt)24"Concrete (Reinforced Recommended)Red Head Fastener1/2" x 3 1/2"Cover overWheelRear InstallationPhysicalStops on BothEnds of RailFront InstallationPhysicalStops onBoth Endsof Rail14
Page 7 and 8: ROLE OF SPECIFIERS AND DESIGNERSSpe
Page 9 and 10: GATE POST WARNINGIMPORTANT NOTICE!B
Page 11 and 12: W ARNINGS AND PRECAUTIONSThe SL-300
Page 16 and 17: CENTER SAFETY EXITW4G B AMS LINKSYS
Page 18 and 19: MS LINKSENSORS1 31 3OPEN LEFT1 3OPE
Page 20 and 21: MS LINKM/S LinkP/N P/N Q410 Q410Pat
Page 22 and 23: MS LINKSENSORS1 3FIREDEPT.EXITLOOP1
Page 24 and 25: QCCA BOPEN STOP CLOSE MAGLOCK ALARM
Page 26 and 27: MS LINKSENSORS1 31 3OPEN LEFT1 3OPE
Page 28 and 29: SAFETY LOOP SYSTEMThe safety loop p
Page 30 and 31: EMERGENCY RELEASEStandardAllen wren
Page 32 and 33: CENTER SAFETY EXITQCCA BOPEN STOP M
Page 34 and 35: SAFETY PRECAUTIONSSECONDARY ENTRAPM
Page 36 and 37: TROUBLESHOOTING TABLECONDITION POSS
Page 38 and 39: SL-3000 PARTS LISTIdler Sprocket As

Manual - Gates

Create successful ePaper yourself

Delete template?

Save as template?