MORTISE TYPE EXIT DEVICE 9500/F9500 SERIES

More documents

Recommendations

Info

$E:\WORK IN PROCESS\Exit Tech Data\PL8400 Model (1)$

9Installation of touch bar to chassis8-32 x 3/8" P.H.P.M.S.NOTE:Chassis screws areshipped in chassisassembly.a1NOTE:For optional "Filler" installationssee "Options" pages 11 & 12 at rear.a28-32 x 3/8" P.H.P.M.S.10Standard installation of end cap mounting bracket*NOTE:An additional screw may beinstalled if door is warped orbowed. (Not supplied)*bcac1/8" (3 mm) Drill 1" (25 mm) Deep (Wood)No. 14 Drill - 12-24 Tap (Metal)3/8" (9 mm) Dia. (Thru bolts)OPTIONAL INSTALLATIONSADDITIONAL HOLE REQUIRED:b1aES(Electric Latch Retraction)MS(Micro Switch)5/16" DIA. (8 mm) LM(Latch Monitor)MD (Magnetic Dogging)DWA(Direct Wired Alarm)See "OPTIONS" pages foradditional information.8
11Adjustment of mortise lock and chassis assemblyBell crankGuard boltLatch boltAdjusting screwAdjusting armLoosen screw in adjusting arm (Do not remove). With bellcrank all the way down adjust lifting armuntil latch bolt moves slightly inward. Tighten adjusting screw. Depress touch bar slowly, watchinglatch bolt. With touch bar fully depressed, bell crank should be all the way up and latch bolt shouldbe fully retracted. If latch bolt is not completely retracted, adjust lifting arm upward.Release touch bar, latch bolt should extend fully. Push inward on guard bolt, then push inwards onlatch bolt. Latch bolt should deadlatch and not retract. If latch bolt does not deadlatch, re-adjustadjusting arm. (Move it down slightly.) Re-check operation as above. Check outside trim functionsif installed.Allow door to close and check for proper alignment of strike and latch bolt.NOTE: Adjusting arm on chassis assembly may have to be cut downon doors under 1 4" 3 in thickness or on composite and wood doorsto allow clearance for travel. If cutting is required measure inside faceof door to outside edge of latch case. With adjusting arm installed onchassis assembly; Use this dimension to measure from rear edge ofchassis, mark and cut adjusting arm to this dimension.On assemblies using thumb piece type trim, adjusting arm will have tobe cut down so it does not interfere with thumb piece bracket on3rear of trim. Remove approximately 8" material from rear of liftingarm on 1 4" 3 thick door. See detail to right.RemoveApproximately 3/8"9
Page 1 and 2: INSTALLATION INSTRUCTIONS9500/F9500
Page 3: DOOR & FRAME PREPANSI 115.1 STANDAR
Page 7: 7Chassis installation. If using GK9
Page 11 and 12: OPTIONS"CD" (CYLINDER DOGGING) OPTI
Page 13 and 14: OPTIONS"MD" (MAGNETIC DOGGING) OPTI

MORTISE TYPE EXIT DEVICE 9500/F9500 SERIES

Create successful ePaper yourself

Delete template?

Save as template?