Gold Maxi Manual - Lenz USA

Gold Maxi Locomotive decoder 143 (2) 1 ABC direction-dependency deactivated 04 (3) 1 Activate push-pull operation without intermediate 0stop5 (4) 1 Activate push-pull operation with intermediate 0stop6 (5) 1 Stopping with DC independent of the polarity 0(only if Bit 3 is deleted in CV29).7 (6) 1 Signal stop activated with external contact 08 (7) 1 Push-pull operation activated with external0contact52 0-255 Braking distance with activated constant braking 50distance53 0-255 Slow approach with ABC 4854 0-255 Stopping time in push-pull operation, 1 to 256 sec 455 0-255 Sets brightness at function outputs A and C,255255=max56 0-255 Sets brightness at function outputs B and D,255255=max57-59Function mapping:Each bit of the CV stands for a function of the digitalsystem: Bit 1(0) for function 1, Bit 2(1) for function 2and so on up to Bit 8(7) for function 8. If you wish toallocate a function to the dimming, the respective bitmust be set.57 0-255 Dimming (no From the factory setting) 058 0-255 Shunting speed (From the factory setting F3) 459 0-255 Switching off the delay (From the factory setting F4) 860 0-255 Lighting effect at function outputs A and B. The units 0digit of the value stands for function output A, thetens digit for function output B:0 No effect1 Marslight2 Gyrolight3 Strobe4 Double strobe61 0-255 Function mapping: lighting effect at function outputs 0A and B62 0-255 Lighting effect at function outputs C and D. 0The tens digit of thevalue stands forfunction output D:0 No effect1 Flashing at sametime as functionoutput CThe units digit of the valuestands for function output C:0 No effect1 Flashing2 Flickering type 1 (smooth)3 Dimming with value fromCV552 Flashingalternately tofunction output C3 Flickering type 214