BVM-40 Battery Voltage Monitor User's Guide - Alber

More documents

Recommendations

Info

Using the BVM6.2. Setting the Total Jar NumberAt the Setup Menu screen, to select Total Jars, press the up or down button so the cursorpoints to Total Jars, then press both buttons simultaneously. The Total Jars screen displaysthe number of jars selected.TOTAL JARS( 20 )Figure 4. Total Jars ScreenTo change the number of jars, press the up or down button. To save and exit, press bothbuttons at the same time. At the message Save Setting? Yes No, to confirm save, point thecursor to Yes and press both buttons simultaneously. After the message Sending setup data.Please wait, the Summary screen appears.6.3. Viewing Jar VoltagesTo view voltage readings for each jar, at the Summary screen, press the Jar Select up or downbutton to display the Jar Voltage screen and step through the readings.JAR VOLTAGEJAR 01: 12.39VFigure 5. Jar Voltage ScreenTo advance rapidly through the readings, press and hold either button. To return to theSummary screen, press both buttons at the same time.8
Calibrating the BVM7. Calibrating the BVMCalibration of the BVM-40 is done at the factory. This function is usually not accessed by theuser. If the BVM needs calibration, contact Albér.WARNING: High voltage or current may be present inside the equipment and on the equipmentterminals. Calibration must be performed only by technically qualified persons. Observeelectrical safety precautions when removing and installing equipment covers, and whenconnecting leads and making adjustments.WARNING: Dangerous voltages may be present in the jar/battery area. Only qualified personnelshould perform calibration or use the DVM to measure the voltage of Jar 1.7.1. Selecting the Calibration OptionTo calibrate the BVM-40, first use a calibrated DVM to measure the voltage of Jar 1. TheBVM power may be on or off when you take the measurement. Write down the valuemeasured.At the Cell voltage display screen , press the up and down button simultaneously to get to theSetup menu, from there point move the cursor to Calibration, then press both Jar Selectbuttons simultaneously. The Calibration screen displays A/D Counts and Voltage for Jar 1.Adjust the cell voltage value displayed in this window to the previously measured value, TheA/D Counts value is used during manufacturing and is not user adjustable. The A/D Countswill be cycling on and off every 4 seconds, to send calibration, press the jar select up anddown buttons simultaneously at any time when the AD counts are displayed.ADJUST VOLTAGE TOMATCH JAR 1 VOLTAGEA/D CNTS VOLTAGE3963 12.392VFigure 6. Calibration ScreenTo change the BVM displayed voltage to match the measured reading, press the up or downbutton. To advance rapidly, press and hold the button. To save and exit, press both buttons atthe same time. At the message Save Setting? Yes No, to confirm save, point the cursor to Yesand press both buttons simultaneously. After the message Sending calibration data. Pleasewait, the Summary screen appears.9
Page 5 and 6: 1. WARRANTY AND LIMITATION OF LIABI
Page 7: Table of Contents1. SAFETY INFORMAT
Page 10 and 11: System Requirements2. System Requir
Page 12 and 13: Panel Controls and Indicators4. Pan
Page 14 and 15: Installing the BVM5.2. Voltage Sens
Page 18 and 19: Preventive Maintenance8. Preventive
Page 20 and 21: Specifications10. BVM-40 Parts List

BVM-40 Battery Voltage Monitor User's Guide - Alber

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?