M-360 / V-460 - Engraving Systems Support

INSTALLATION• Raster to Vector Conversion Software (user supplied)Adobe Streamline or CorelTRACE• CAD Software (user supplied)AutoCAD or AutoCAD LT for Windows• FONTS (user supplied)Use True Type fonts ONLY. Do not use PostScript or bitmapped fonts.System Assembly3Cart(1) Back panel(2) Legs (both are identical)(3) 1/4-20 x ½, socket head screws with lockand flat washers(4) Nuts (4)(5) Non-locking casters(6) Locking casters(7) 10-32 x 1/4 socket head screws (serve asguides for the main enclosure)(8) 10-32 x 3/8 socket head screws with lockand flat washers(9) Connect to main enclosure385299413697952943679• Assemble the cart as it appears in thediagram but leave all of the screws slightlyloose except for the casters, which shouldbe tightened as far as it can go into thecart leg.• With the assistance of one or two otherpeople, place the system on top of cartand secure with the screws provided.• Open front door all the way to ensure thatit does not come in contact with the cartlegs. If it does, gently spread the legsapart. Securely tighten all the screws andre-check.• Attach your exhaust system’s flexiblerubber hose to the exhaust port at the rearof the laser system and secure with ahose clamp.• Locate the laser system in its final restinglocation.• Place a bubble level across the front (2) and rear legs (3). Adjust the caster height using theadjustment screw (4) until both the rear part and the front part of the legs are level with respect toeach other. Once the system is level, secure all casters by tightening the nut (5) up against the cartleg.• Open the top door and remove the rubber band that is holding the arm in place.• Remove any remaining packing materials, accessories or any other items that may be located insidethe cabinet or on top of the engraving table.54321Section 2-3