M-360 / V-460 - Engraving Systems Support

MATERIAL SETTINGS GUIDECORKRASTER ENGRAVINGLASER WATTAGE POWER SPEED PPI PASS DEPTH25 80 38 500 1 .010”30 80 45 500 1 .010”35 80 52 500 1 .010”40 80 60 500 1 .010”45 80 67 500 1 .010”50 80 75 500 1 .010”55 80 84 500 1 .010”60 80 90 500 1 .010”VECTOR ENGRAVINGLASER WATTAGE POWER SPEED PPI PASS DEPTH25 12 4.0 500 1 .010”30 10 4.0 500 1 .010”35 9 4.0 500 1 .010”40 8 4.0 500 1 .010”45 7 4.0 500 1 .010”50 6 4.0 500 1 .010”55 5 4.0 500 1 .010”60 4 4.0 500 1 .010”VECTOR CUTTINGLASER WATTAGE POWER SPEED PPI PASS DEPTH25 60 1.6 100 1 .060”30 50 1.6 100 1 .060”35 43 1.6 100 1 .060”40 38 1.6 100 1 .060”45 33 1.6 100 1 .060”50 30 1.6 100 1 .060”55 27 1.6 100 1 .060”60 25 1.6 100 1 .060”COMMENTSCork is not very popular for engraving but it does engrave and cut nicely. Cork is mainly used for makinggaskets by vector cutting the gasket patterns.LASER CUTTING THIS MATERIAL CAN CAUSE FLAMING AND SPARKING. Usecaution when attempting to cut this material. It would be better to use a longer focallength lens to prevent the lens from being damaged during processing. NEVER leavethe machine unattended while processing any material. Damages caused byprocessing any material ARE NOT covered under warranty.Section 5-11