G:\Government\Document Files\Handbook ... - Granta Design

MIL-HDBK-5H1 December 1998 ! " " $! % ! "#$!Specification .................AMS-QQ-A-250/25Form ..........................SheetPlateTemper .......................Thickness, in,. ................Basis .........................0.040-0.062T760.063-0.1870.188-0.2490.250-0.499T76510.500-1.000 aS S S S SMechanical Properties:F tu , ksi:L ..........................LT .........................F ty , ksi:L ..........................LT .........................F cy , ksi:L ..........................LT .........................F su , ksi ......................F brub , ksi:(e/D = 1.5) ................(e/D = 2.0) ................F bryb , ksi:(e/D = 1.5) ................(e/D = 2.0) ................e, percent:LT .........................6667565655594110313380928676857575660401041358194869705959586240107139849786869585857604010513387104868685757565940103131871036E, 10 3 ksi:Primary ...................Secondary .................E c , 10 3 ksi:Primary ...................Secondary .................G, 10 3 ksi ...................µ ............................10.39.810.510.0...0.3310.310.010.510.2...0.3310.310.010.610.3...0.33Physical Properties:, lb/in. 3 ....................C, K, and .................0.101...a These values have been adjusted to represent the average properties across the whole section, including the1-1/2 percent per side nominal cladding thickness.b Bearing values are “dry pin” values per Section 1.4.7.1. See Table 3.1.2.1.1.3-354