Kawasaki 19.2V Cordless Drill - Alltrade Tools

TORQUE SETTINGSTo prevent damaging the tool or driving screw too deepinto work piece, release the trigger when you feel the clutch slip.THE CONTROL RING ADJUSTS THE LEVEL OF TORQUE:• For light duty work, use lower settings.• For heavy duty work, use higher settings.PROPER SETTING FOR DRIVING SCREWS:1. Set the ring on the lowestsetting to begin.2. Try tightening the first screw.If the drill drives smoothly,proceed with the next screw.3. If the Drill’s clutch slips,increase the torque settingand try again until the Drilldrives the screw without incident.CONTROL RINGSCREWDRIVINGWHEN DRIVING FASTENERS:• Always start slowly and gradually increase the speed of the Drill.• Release the trigger when you feel the clutch slip.• Always keep the driver bit straight to prevent damage to the screw.• Hold the Drill with both hands to ensure control if the bit should stick or slip.• To prevent wood from splitting, drill pilot holes into the wood before drivingin the screws.DRILLING METALWHEN DRILLING HARD METALS:• Apply a lubricant, such as cutting oil, to the tip of the bit.• Start with a small hole then enlarge to the required size. Make sure the bit isactually cutting and not spinning in the hole as this will dull the edges of the bit.• Keep enough pressure on the bit to keep it drilling through the material.DRILLING MASONRYFOR LOW SPEED SETTING:• Slide the switch on top of theDrill to Position 1 for hightorque applications and drivingscrews.FOR HIGH SPEED SETTING:• Slide the switch to Position 2for light duty projects.HIGH / LOW SPEED (GEAR) SHIFTINGLOW SPEEDHIGH SPEEDWHEN DRILLING MASONRY:• Masonry can be brittle so be careful not to apply too much pressure and crackthe material.• Apply enough pressure to keep the bit cutting and not spinning in the hole as thiswill dull the edges of the bit.• Bricks and similar soft materials will require less pressure, concrete will requiremuch more.DRILLING WOODUse twist bits to drill holes in wood. Make sure the bits are sharp. Pull the bitsout of the hole frequently to clear chips from the flutes as an overburdened bitmay overheat.HINTS FOR OPTIMUM USEDRILLING:• Keep the right amount of pressure in a straight line with the drill bit. Too little andthe bit will spin without cutting, too much and the motor may stall.1516