EMB-505 - Embraer

GROUND HANDLING ANDSERVICING HANDBOOKHARD COPY IS UNCONTROLLED. ONCE PRINTED, THIS PAGE MUST NOT BE RETAINED FOR FUTURE REFERENCE.BEFORE USING, MAKE SURE THIS HARD COPY IS THE LATEST ISSUE.(c) Close the window shades.(d) Set the gust locks. Refer to AMM SDS 27-70-00.(e) Install the covers to these parts:1. Pitot-static probe (GSE 003).2. IASP - (Integrated air data and stall protection probe)(f) Install the engine covers (GSE 030) as follows (Figure 202, Sheet 3):1. Install the engine air inlet plug to engine air inlet.2. Install the engine exhaust outlet plug perpendicular to engine air outlet.3. Put the plug into the correct position and pull it back through the handle.(g) Cover the outlet and inlet openings that follow with a cotton fabric or equivalentattached to the aircraft skin with adhesive tape:1. Ground cooling fan inlet.2. Ground cooling fan exhaust.3. Condenser fan inlet.4. Condenser fan exhaust.5. Ram-air inlet.(h) Close all the doors and access panels.(i) Make sure that wheel chocks are installed.(j) Where there are freezing or ice conditions, do the subsequent step:1. Remove, drain and storage the waste tank. Refer to GHSH TASK12-15-03-600-801-A/300.NOTE: For matter of hygiene, we recommend that the wastetank be serviced.2. Drain the water tank. Refer to GHSH TASK 12-15-03-600-801-A/300.EFFECTIVITY: ALL 10-10-00-500-801-A/200Page 202Rev.01 - MAY 28/10Copyright © by EMBRAER S.A - All rights reserved - See title page for details.