Hardware User's Manual - Kamery IP

More documents

Recommendations

Info

E91 Hardware User’s ManualInstallation ProcedureRemove the cover of the camera by loosen the 3 screws holding it.Surface MountDrill three holes with φ3.5 on the ceiling according to the marks provided on the template.Route cables through the ceiling, taking as a reference the Conduit Hole on the drillingtemplate. Or you may take off the removable part from the cable exit hole at the rear of thecover by sliding it out from the cover to route the cable from the camera.8www.acti.com
E91 Hardware User’s ManualUse the camera body and locate the correct three screw holes.Tighten the camera body to the ceiling using the 3 screws included.Please make sure the screw is flat on the plate, protruding is incorrect.Attach the cover back to the camera body and tighten the 3 screws.9www.acti.com
Page 3 and 4: E91 Hardware User’s Manual0. Prec
Page 5 and 6: E91 Hardware User’s ManualFeature
Page 7: E91 Hardware User’s ManualPhysica
Page 11 and 12: E91 Hardware User’s ManualTighten
Page 13 and 14: E91 Hardware User’s ManualAttach
Page 15 and 16: E91 Hardware User’s Manual2. Acce
Page 17 and 18: E91 Hardware User’s Manual6. Afte

Hardware User's Manual - Kamery IP

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?