Bondtec IAC 501 Inhibited Acid Cleaner - Smart-Info Limited

Bondtec IAC 501Inhibited Acid CleanerDESCRIPTIONIAC 501 is a concentrated acid cleaner. It contains organic acids blended with selected wettingagent, corrosive inhibitors and cleaning surfactant.USESIAC 501 is specially formulated to remove the rust stain, lime deposit, and dirt on thesurface of green or red granite stone and mosaic tiles. The built in corrosion inhibitorprevents damage to the surface being treated during and after the cleaning process.PROPERTIESAppearance : cleanSolubity : infinite in waterPH Value : 2 (approx.)Viscosity : 100 cps at 25℃Fire Point : non-inflammableAPPLICATIONMixing Ratio -IAC 501 : waterHeavy Duty - 1 : 1-2 (Water)Medium Duty -General Cleaning -1 : 5-9 (Water)1 : 10-20 (Water)PROCEDURE• Wet the substrate with water before hand.• Apply the diluted solution onto the gummy surface upwards with a brush.• Allow the chemical to react for 5-10 minutes.• Brush and rinse the surface at the same time.• Bright surface can be obtained after it has dried.Remark: if the deposit is too thick a second applicationwill be necessary; or repeat using higher strength STONE CLEANER IAC 401Room. 1505, 15/F, HK Worsted Mills Ind. Bldg., 31-39 Wo Tong Tsui Street., Kwai Chung, N.T., H.K.Tel: (852) 2409 9782 Fax: (852) 2406 8284 Web Site: http://www.bondtec.com.hk E-mail: info@bondtec.com.hk

PackageBondtec IAC 501Inhibited Acid CleanerIAC 501 is supplied in 20 kg/drumTECHNICAL SERVICEOur technical Service Department is available to assist you in the correct use of ourproducts and its resources are at your disposal entirely without obligation.PRECATTION• IAC 501 must not be used with any alkaline cleaning compound.• Avoid contact with skin and eyes.• Protective clothing should be worn.• Apply copious amounts of water to splash marks.• If eye contact should occur seek medical advice immediately.• Never use/splash on window/glass surface. Cover window nearby with oilfilm/plastic sheet.• IMPORTANT NOTETo the best of our knowledge and belief, the information contained in this leaflet is true and accurate, but asconditions of use and any labour involved are beyond our control, the end user must satisfy himself by priortesting that the product is suitable of his specific application, and no responsibility can be accepted, or anywarranty given by our Representatives, Agents or Distributors. Products are sole subject to our StandardConditions of Sale and the end user should ensure that he has consulted our latest literature.Room. 1505, 15/F, HK Worsted Mills Ind. Bldg., 31-39 Wo Tong Tsui Street., Kwai Chung, N.T., H.K.Tel: (852) 2409 9782 Fax: (852) 2406 8284 Web Site: http://www.bondtec.com.hk E-mail: info@bondtec.com.hk