installation and operating instructions for aq-1 and aq-2 power vent ...

More documents

Recommendations

Info

FIGURE CCONNECT THIS SPILL SWITCHLEAD TO ECO TERMINAL BYPUSHING IT ON OR CUTTING ANDREPLACING ITS END WITH ANEYELET TERMINAL.Aquastar 170vp ModelCONNECT SPILL SWITCHLEAD TO ECO TERMINALREMOVE HEAVYGAUGE WIRE FROMUPPER AND LOWERECO TERMINALS.3. On Aquastar 125X/B models the ECO ismounted on the lower left outlet waterpipe. (See figure D)a. Remove one lead connecting to ECOterminal, it does not matter which one isdisconnected.b. Attach 1/4" quick connect terminal end oflinear spill switch cable to now exposedterminal of the ECO.c. Remove the eyelet ended terminal fromthe other spill switch cable. Affix the push onmale spade connector, which is provided withthe AQ1, to this spill switch cable.d. Connect this male spade connector to theremoved lead wire from step 3.a.On Aquastar 125X/B models the linear spill switchshould be attached to the upper right-hand side on thedraft hood diverter (see figure E). There are two holesprovided for attachment on this diverter and only thefront most hole should need to be used. With the #12self tapping sheet metal screw securely mount thespill switch bracket to the diverter. For ease of accessposition it so the reset button faces outward and thenbend the bracket so the switch can stand vertically.The copper capillary sensing tube should then be directedto the left by looping it over the diverter opening,up in front of the 5" diameter vent pipe and then downacross the upper left hand draft diverter.FIGURE DECOFIGURE E125X/B ModelsDISCONNECT EITHER WIRE FROM ECO.PUSH ON ONE SPILL SWITCH LEAD CABLETO ECO AND OTHER (RETROFIT FIRST)INTO EITHER WIRE THAT WAS REMOVED.CAPILLARY SENSING TUBERESET BUTTONSPILL SWITCHCABLES5
COMMON SETUPSAquastar 170vp ModelLocation of Linear SpillageSwitch (Route Spillage SwitchCables behind back)125X & 125B ModelsMount gas pressureswitch against wallSee Figure E for location of Linear Spillage Switch6
Page 1 and 2: INSTALLATION AND OPERATING INSTRUCT
Page 3 and 4: Before beginning installation revie
Page 5: f. Hand thread the pressure tap fit
Page 9 and 10: INSTRUCTIONS(DO NOT BEGIN THESE PRO
Page 11 and 12: SAFETY INTERLOCK TEST1. Open the ga
Page 13 and 14: AQUASTAR SAFETY INTERLOCK DIAGRAMUP

installation and operating instructions for aq-1 and aq-2 power vent ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?