Passport 8500 Radar Detector - Escort Inc.

Details of EZ-Programming OptionsPilot Light (Power-on indication)Note: When you are using the Dark mode,the display will only show HD, AD, or CD,(Highway-Dark, Auto-Dark, or City-Dark).PilotHWY (Full description)In this setting, Passport will display“Highway,” “City,” or “Auto” as its poweronindication. (factory default)Pilot H (Letter)In this setting, Passport will display “H” forHighway, “C” for City, and “A” for Auto.Pilot H.> (Letter with scanning dot)In this setting, Passport will display “H” forHighway, “C” for City, and “A” for Auto.Also, a single dot will continuously scrollacross the display.Pilot+ (Symbol)In this setting, Passport will display “+” forHighway, “.” for Auto, and “–” for City.Pilot+.> (Symbol with scanning dot)In this setting, Passport will display “+” forHighway, “.” for Auto, and “–” for City. Also,a single dot will continuously scroll acrossthe display.Pilot+> (Scanning symbol)In this setting, Passport will display “+” forHighway, “.” for Auto, and “–” for City. Eachwill continuously scroll across the display.14Pilot V (Vehicle voltage)In this setting, Passport will continuallydisplay “H” for Highway, “C” for City, and“A” for Auto, and the vehicle’s voltage. Ifthe vehicle’s voltage drops below 10.5 volts,a low voltage warning is displayed, followedby an audible alert. A high voltage warningis also given if the voltage goes above 16.5volts. The high-voltage warning is alsofollowed by an audible alert.Power-on SequencePwrOnSTD (Standard)In this setting, each time you turn onPassport, it will display “Passport 8500,”“LASER,” “Ka-band,” “K-band,” “X-band,”followed by a brief X-band alert. (factorydefault) If any bands have been disabled, adouble X-band tone and correspondingmessage (i.e. “X OFF”), will alert you thatone or more bands have been turned off.PwrOnFST (Fast power-on)In this setting, Passport will provide a singleX-band tone if all bands are enabled. If anybands have been disabled, a double X-bandtone and corresponding message (i.e. “XOFF”), will alert you that one or more bandshave been turned off.Signal Strength MeterMeterSTD (Standard meter)In this setting, the meter displays the bandof the received signal, and a bar graph showsthe relative signal strength. (factory default)