Digital Modes II

More documents

Recommendations

Info

Page 20 05/26/051. Setup the TX Page as follows, (DO NOT CHANGE THETxBPF/TxLPF, TUNE BUTTON INFO, or PORT value):Figure 9- 20 -
Page 21 05/26/057. Set up the MISC page as follows, (DO NOT CHANGETHE FIFO, or DEVICE ID):Figure 98. Note above: DO NOT change anything in the CLOCKwindow.9. Once you have these items set up locate a station thatbelieves they are calibrated correctly. They become the"Standard" for all.10. Have them send a picture to you. After that picture iscomplete Select the "SYNC" tab, (you can do this whilethe picture is being received), then select the NICONICO(Happyface), button ONLY after the picture is complete.A number will appear in a small white box in the upperpart of the screen. This is your error from the selected"Master" station.11. You may press the "MEM" button. This will lock yourcomputer to the "Master" stations clock frequency. Yourreceive is now setup.12. Get the clock set frequency from the MISC Tab aboveand write it down.- 21 -
Page 1 and 2: Page 1 05/26/05An overview of the D
Page 3 and 4: Page 3 05/26/05• Step by step of
Page 5 and 6: Page 5 05/26/05• Rigblaster Plus
Page 7 and 8: Page 7 05/26/05• Tigertronics 5,6
Page 9 and 10: Page 9 05/26/053. The Modes:• MT-
Page 11 and 12: Page 11 05/26/05• AMTOR Mode B, o
Page 13 and 14: Page 13 05/26/05Figure 4. MixW, not
Page 15 and 16: Page 15 05/26/05Figure 5: MT63 Term
Page 17 and 18: Page 17 05/26/053. Setup of MT63 us
Page 19: Page 19 05/26/055. Set up the RX Pa
Page 23 and 24: Page 23 05/26/052. MARS Station Res
Page 25: Page 25 05/26/05References1. Bell L

Digital Modes II

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?