Infinity Operations Manual (96402,96403, 96406, 96407) - Whip Mix

More documents

Recommendations

Info

FIELD SERVICEREPLACEMENT INSTRUCTIONS: 15295 JELRUS THERMOCOUPLEFor assistance call 1-800-626-5651 or write to: tops@whipmix.comCAUTION!TO PREVENT INJURY, ALWAYS TURN POWER OFF AND DISCONNECT THE OVEN’S POWERCORD BEFORE PERFORMING SERVICE. VERIFY THAT UNIT IS COOL TO THE TOUCH.Front View LargeRear View MediumRear View Large10Screws4 Screws Bottom Cover6 Screws Bottom CoverUnplug oven, remove trays from inside, then lay oven on its side and remove screws from bottom and back covers.Rear Back View MediumRear Back View LargeNote: make sure to run thermocouple wire through loopto hold wire stable before pulling into upper housing.Disconnect heater wires to pull thermocouple out from the muffle, then through the grommet into lower housing.Disconnect thermocouple from the main board.Note: Thermocouple should be wired as shown above. Heater wire must rest over ceramicsheath not to come in contact with bare wire or fiber sleeve.25
FIELD SERVICEREPLACEMENT OF THE SSR (Solid State Relay) (PN 96225)1. Remove the lower bottom panel (Figure 2, Page 6).2. Note and record the color and location of each of the four wires on the SSR terminals (Figure 5,Page 24). Remove each of the four wires by pulling straight up on the connecter. DO NOT PULLON THE WIRES.3. Remove the two nuts and screws that hold SSR in place. Lift SSR off the chassis (Figure 5, Page 24).4. Put the new SSR in place on the rear panel. Locate the SSR so that the center terminal will facedownward when the bottom panel is in place.5. Replace the four wires on the SSR (Figure 5, Page 24).6. Replace the lower bottom panel (Figure 2, Page 6).26
Page 2 and 3: TABLE OF CONTENTSIntroduction .....
Page 4 and 5: SPECIFICATIONSINFINITY MElectrical
Page 6 and 7: PROGRAMkey parts identification and
Page 8 and 9: installationunpack and set-up1. Unp
Page 11 and 12: operationprogram and operate - TWO
Page 13 and 14: operationprogram and operate - four
Page 15 and 16: OPERATIONedit while a program is ru
Page 17 and 18: OPERATIONSample three stage program
Page 19 and 20: ERROR CODESerrorcode DESCRIPTION PR
Page 21 and 22: SERVICE6. When the tablet begins to
Page 23 and 24: Figure 4INFINITY WITH UPPER REAR PA
Page 25: Figure 5INFINITY WIRING DIAGRAM24
Page 29 and 30: SPARE PARTS LISTSPARE PARTS FOR INF
Page 31 and 32: PROGRAM CARD FORMSProgram #Metal(s)

Infinity Operations Manual (96402,96403, 96406, 96407) - Whip Mix

Create successful ePaper yourself

Delete template?

Save as template?