MTR-40F REV 0.p65 - Southern Tool

More documents

Recommendations

Info

MTR-40F— PRE-INSPECTION/INITIAL START-UPFigure 6. Engine Oil Dipstick (Oil Level)Season or TemperatureSpring, Summer or Autumn+120° F to +15° FWinter+40° F to +15° FTable 3 Motor Oil GradeGrade of motor oil(higher than MS class)SAE 30SAE 30Below+15° FSAE 10W-30Inspection1. Check all nuts, bolts fasteners for tightness. Retighten asnecessary.2. Clean any dirt from the recoil starter and foot pedestal. Wipethe entire unit clean before operating.3. Replace any missing or damaged Safety Operation decals.4. Adjust height of handle. Adjust handle by loosening nuts andmoving handle to suit operation. Retighten nuts.This section is intended to assist theoperator with the initial start-up of theMTR-40F rammer. It is extremelyimportant that this section be readcarefully before attempting to use therammer in the field.DO NOT use your rammer until this section is thoroughlyunderstood.CAUTION:Failure to understand the initial start-upprocedures of the MTR-40F rammer couldresult in severe damage to the rammer orpersonal injury.See Figure 1 (Page 13) for the location of any control referencedin this manual.Initial Start-upThe following steps outline the procedure for starting the engine:1. Open the fuel shut- off valve by moving the fuel cocklever to the open position (Figure 7).Figure 7. Fuel Shut-Off Valve (Open)PAGE 16 — MTR-40F— PARTS & OPERATION MANUAL — REV. #0 (01/21/04)
MTR-40F— INITIAL START-UP2. Set the engine ON/OFF switch (Figure 8) to the "ON"position (start).5 Grip the recoil starter (Figure 11) handle and pull it until youfeel a slight resistance. Then pull sharply and quickly. Returnthe recoil starter handle to the starter position before releasing.Figure 8. ON/OFF Switch (ON Position)3. Move the throttle lever to the "IDLE" position (Figure 9).Figure 11. Recoil Starter6. If engine fails to start, move the choke lever (Figure 10) tothe half open position to avoid flooding.7. Repeat steps 1 through 6.8. If the engine does not start after repeated attempts,check the spark plug for excess fuel. Clean and replacethe spark plug as needed.Figure 9. Throttle Lever (Idle)4. In cold weather, start the unit with choke lever "Fully Closed"(Figure 10). In warm weather or when the engine is warm,the unit can be started with choke halfway or completelyopen.Figure 10. Choke Lever (Closed)MTR-40F— PARTS & OPERATION MANUAL — REV. #0 (01/21/04) — PAGE 17
Page 1 and 2: OPERATION AND PARTS MANUALTamping R
Page 3 and 4: HERE'S HOW TO GET HELPPLEASE HAVE T
Page 5 and 6: When ordering parts,please supply t
Page 7 and 8: MTR40-HS — SAFETY MESSAGE ALERT S
Page 10 and 11: MTR-40F — OPERATION AND SAFETY DE
Page 12 and 13: MTR-40F — SPECIFICATIONSTable1.MT
Page 14 and 15: MTR-40F — BASIC ENGINEFigure 2. E
Page 18 and 19: MTR-40F— OPERATIONOperation1. To
Page 20 and 21: MTR-40F— MAINTENANCE (RAMMER/ENGI
Page 22 and 23: MTR-40F— TROUBLESHOOTING GUIDETAB
Page 24 and 25: How to read the marks and remarks u
Page 26 and 27: MTR-40F— NAMEPLATE AND DECALSNAME
Page 28 and 29: MTR-40F— CRANKCASE AND ENGINE ASS
Page 30 and 31: MTR-40F— CRANKCASE AND ENGINE ASS
Page 32 and 33: MTR-40F — GUIDE CYLINDER ASSY.GUI
Page 34 and 35: MTR-40F— TANK AND HANDLE ASSY.TAN
Page 36 and 37: MTR-40F— FOOT ASSY. (OPTION)FOOT
Page 38 and 39: MTR-40F— NARROW FOOT ASSY. (OPTIO
Page 40 and 41: MTR-40F— TRENCH SHOE ASSY. (OPTIO
Page 42 and 43: ROBIN EH-09 ENGINE — CRANKCASE AS
Page 44 and 45: CRANKSHAFT AND PISTON ASSY.ROBIN EH
Page 46 and 47: INTAKE AND EXHAUST ASSY.ROBIN EH-09
Page 48 and 49: ROBIN EH-09 ENGINE —GOVERNOR ASSY
Page 50 and 51: ROBIN EH-09 ENGINE —BLOWER HOUSIN
Page 52 and 53: ROBIN EH-09 ENGINE — CARBURETOR A
Page 54 and 55: ROBIN EH-09 ENGINE —ELECTRIC DEVI
Page 56 and 57: Effective: October 1, 2002TERMS AND
Page 58: OPERATION AND PARTS MANUALHERE'S HO

MTR-40F REV 0.p65 - Southern Tool

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?