Palax KS35 Ergo/S Manual - Hakmet

2.11 Bringing the conveyor into the work position, Figs. 9 and 1011 Release the lock A and the lock chain Bfor the conveyor, Fig. 9. Unwind the winch wire a few rounds. Pull out the conveyor and leave itsupported by the winch rope. Lower the conveyor to the ground usingthe winch. Pull open lock A (Fig. 10). Swing down the top of the conveyor. Remove the support bar B for theconveyor chain (Fig. 10) and attach it tothe holes C at the edge of the conveyor.AB92.12 Bringing the conveyor into the transport position, Fig. 9 and 10Lower the conveyor to the ground andconnect the support bar B for theconveyor chain.Pull lock A open and lift up the conveyortop.Ensure that lock A is properly locked.Raise the conveyor using the winch.Tighten the winch wire lightly in order toprevent it uncoiling from the spool.Lock the conveyor to the transportsupport using the lock, the chain and thepin.10BCAWARNING!Always hold by the winch handle as you lower the conveyor.3 Operating the Palax KS 35 firewood processor3.1 TransmissionAll actuators for the machine including the in-feed conveyor, firewood conveyor and chainsaware equipped with hydraulic motors.The dual hydraulic pump of the tractor-driven machine is equipped with a gearbox and apower take-off shaft or an electric motor.Palax_KS_35_Ergo+S_v4_07_EN.doc