TRANQUILITY WOOD STOVE - Home Depot

More documents

Recommendations

Info

INSTALLATIONWall Pass‐ThroughsIn Canada, the installation must conform to CAN/CSA‐B365 when passing through combustible construction.Page | 10
INSTALLATIONApproved Venting Method 1: Through the Wall Factory Built Chimney10 ft.Termination CapStorm CollarRoof Flashing2.0 ft.3.0 ft.The 10‐3‐2 Rule: The chimney systemmust terminate 3.0 ft. above the pointwhere its centerline passes through theroof AND the chimney must terminate2.0 ft. above any part of the dwellingwithin a 10 ft. radius of the chimney.Wall ThimbleChimney Connector(Single or Double Wall)18.0 in.Class A Chimney SystemTee and Tee Support• Prefabricated chimney systems must conform to UL‐103HT (2100 °F) for the U.S. and ULC‐S629 (650°C) forCanada.• This wood burning unit is only listed for installation with 6.0” diameter chimney connector and chimney systems.Installing this unit on prefabricated chimneys larger than 6.0” diameter will result in decreased draft and thepotential for poor unit performance.• Follow all venting system manufacturer’s installation requirements and required clearances.• Use three sheet metal screws at each single wall chimney connector joint (check manufacturer’srecommendations when double wall chimney connector is used).• Drill three holes in the flue collar of the unit and attach the chimney connector to the unit using sheet metalscrews.• Properly attach the prefabricated chimney system to the home in strict accordance with the prefabricatedchimney system manufacturer’s instructions.• Avoid numerous elbows and excessive horizontal runs as both will lead to poor draft and increased creosoteaccumulation. Horizontal runs of chimney connector must never exceed 4.0 ft. and the overall length of thechimney connector must not exceed 8.0 ft.• Special adapters and slip connectors are available to eliminate the need to cut single wall chimney connector.Double wall chimney connector must be used with these slip connectors, as it cannot be trimmed to length.Please Note:Installation diagrams are for reference purposes only and are not drawn to scale, nor meant to be used as plans for each individualinstallation. Please follow all venting system requirements, maintain the required clearances to combustibles, and follow all localcodes.Page | 11
Page 1 and 2: TRANQUILITY WOOD STOVEINSTALLATION
Page 3 and 4: TABLE OF CONTENTSIntroduction• In
Page 5 and 6: SPECIFICATIONSHeating Specification
Page 7 and 8: • INSTALLATIONClearances to Combu
Page 9: INSTALLATIONAdditional Venting Info
Page 13 and 14: INSTALLATIONApproved Venting Method
Page 15 and 16: FLOOR PROTECTION• This wood stove
Page 17 and 18: OPERATIONBreak‐In Fires• This w
Page 20 and 21: Page | 20MAINTENANCEDaily Maintenan
Page 22 and 23: REPLACING COMPONENTSGlassThis unit
Page 24 and 25: REPLACEMENT PARTS LISTDiagramNo.Des
Page 26 and 27: Page | 26You may write your unit’
Page 28 and 29: ProcedurePurchaser must give notice
Page 30: Important NoticeThis registration i

TRANQUILITY WOOD STOVE - Home Depot

Create successful ePaper yourself

Delete template?

Save as template?