Snapper Lawn Tractor Hydrostatic Drive Electric Clutch Series G ...

More documents

Recommendations

Info

Section 4 - ADJUSTMENT & REPAIRWARNINGDO NOT attempt any adjustments, maintenance orservice with the engine or blades running. STOPblades. STOP engine. Set brake. Remove key.Remove spark plug wire from spark plug and securewire away from spark plug. Engine and componentscan be extremely hot. Avoid burns by allowing engineand components sufficient time to cool.4.4.8. DECK BELT REMOVAL & REPLACEMENT42" Deck <strong>Drive</strong> Belt1. Place tractor on a firm level surface.2. Turn engine "OFF". Remove key.3. Remove mower deck. Refer to Section “DECKREMOVAL”.4. Remove deck idler tension spring. Loosen bolts thatsecure the end of the spindle pulley covers and rotatecover around out of the way. See Figure 4.32 & Figure4.33.PULLEYCOVERFIGURE 4.33ROTATE PULLEYCOVER OUT OFTHE WAY9. Adjust idler pulley belt guide if necessary to obtain1/16" clearance between belt and belt guide. SeeFigure 4.34.1/16” CLEARANCE(TYPICAL)STATIONARYIDLERBELTTENSIONIDLERBELTGUIDETENSION IDLERSPRINGREMOVE SPRING FROMTENSION IDLERSPINDLE PULLEYSFIGURE 4.34FIGURE 4.325. Remove old belt.6. Replace with new belt.7. Reinstall both pulley covers.8. Reinstall mower deck to tractor.28
Section 4 - ADJUSTMENT & REPAIRWARNINGDO NOT attempt any adjustments, maintenance orservice with the engine or blades running. STOPblades. STOP engine. Set brake. Remove key.Remove spark plug wire from spark plug and securewire away from spark plug. Engine and componentscan be extremely hot. Avoid burns by allowing engineand components sufficient time to cool.3. Remove mower deck. See Section on DECKREMOVAL.4. Remove deck idler tension spring. Remove nuts thatsecure the spindle pulley covers. See Figure 4.35.5. Remove belt.6. Install new belt.7. Reinstall both pulley covers.8. Reinstall mower deck to tractor.4.4.8. DECK BELT REMOVAL & REPLACEMENT48" Deck <strong>Drive</strong> Belt1. Place tractor on a firm level surface.2. Turn engine "OFF". Remove key.TOP VIEW OF48” MOWER DECKELECTRICCLUTCHPULLEYENGINE TO DECKDRIVE BELTPART No. 4-6926TENSIONSPRINGSPINDLEPULLEYCOVERSPINDLEPULLEYCOVERTENSIONSPRINGSPINDLE TO SPINDLEMOWER BELTPART No. 2-8334FIGURE 4.3529
Page 6 and 7: Section 2 - OPERATING INSTRUCTIONS2
Page 13 and 14: Section 3 - MAINTENANCE3.2.4. CHECK
Page 15 and 16: Section 3 - MAINTENANCE3.4 ANNUALLY
Page 17 and 18: Section 4 - ADJUSTMENT & REPAIRWARN
Page 27: Section 4 - ADJUSTMENT & REPAIRWARN
Page 33 and 34: Section 4 - ADJUSTMENT & REPAIRAVAI
Page 35 and 36: TROUBLESHOOTING GUIDEPROBLEM PROBAB
Page 37 and 38: MAINTENANCE SCHEDULESUBJECTSERVICER
Page 39 and 40: PRIMARY MAINTENANCE39
Page 41 and 42: PRIMARY MAINTENANCE41
Page 43 and 44: SERVICE NOTES______________________

Snapper Lawn Tractor Hydrostatic Drive Electric Clutch Series G ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?