DN 100 - 1200 mm - Bauernfeind GmbH

Installation of PP-MEGA-PipesFrom DN/ID 100 - 1200 mm the PP-MEGA-Pipes are availablewith a fixed socket or a connection socket. The necessarysealing ring is enclosed separately in order to avoid damages.Before laying the pipes and fittings have to be checked fordamage that may have occurred due to transport or storage.Damaged pipes or fittings must not be installed.The laying should be started at the lower end of the pipeline.The pipes are usually laid so that the sockets face to the top.putting the sealing ring onConnecting of the pipesPut the sealing ring between the first two corrugations of thepipe and make sure that the sealing fits proper.pushing the pipes togetherBefore connecting the pipes you have to make sure that thesliding surfaces are clean. Then grease the inner surface ofthe socket well with usual lubricants. The pipes should beconnected with constant axial force up to the previously markedinsertion depth, without overloading the components.The PP-MEGA-Pipes have to be laid according to the height anddirection limits prescribed by the planning requirements. Pipesof smaller diameters can easily be pushed together by hand.For larger diameters, the use of equipment is required whilethe pipe should be protected at the end.inline socketconnection socketCutting of the pipeYou have to cut the pipes with a fine-tooth saw or anothersuitable tool. Cut the pipe in the center of the trough and verticalto the tubular axle. Ridges and unevenness of the cut pipe endshould be removed with a grater, a rasp or a cutter.Adapter to other materialsThe PP-MEGA-Pipes may be connected to other pipes withan appropriate adapter. It is not recommended to installclamp-connections or other connection options on the outerlayer. You should always use PP-MEGA-adapters. For theconnection to PVC-sewer-pipes according to ÖNORM EN1401-1standard adapters are available.cutting of the pipesadapter