On-The-Vehicle - aesco

More documents

Recommendations

Info

On-The-VehicleInstallation and Set UpInstructions800 Brake Lathe and Portable StandSystem Assembly3.0 Insert the counter balance cylinder shaft intothe three leg trolley and tighten screw.3.3 Retrieve the four hub adapters and place each inthe hub adapter set holder on the portable stand system.3.4 Place the chip tray over the pivot located on thecutting head assembly.3.1 With the help of another person, lift the 800brake lathe and insert the pivot into the receiver onthe portable stand system.3.5 Place the tool tray on the portable stand systemas shown.3.2 Install the pivot-locking lever into the 800 brakelathe pivot and tighten. Note the location of the thickaluminum washer.6 • AMMCO 800 On-The-Vehicle Brake Lathe
On-The-Vehicle3.6 Remove the valve cap from the valve on thecounter balance cylinder. Using shop air (minimum120 PSI) fill the cylinder to its fully extended height.WARNINGDo not exceed 140 PSI of air when fillingthe counter balance cylinder.WARNINGDo not stand over the 800 brake latheand/or portable stand system when pressurizingthe counter balance cylinder.800 Brake Lathe and Portable StandSystem Inspection4.0 Note the location of pivot points for rotation.Lathe Rotation Pivot and Lock System3.7 Using a small tool, release air pressure until the800 brake lathe drops to about 5-inches of shaft showing,as shown in photo below.Lathe Tilt Pivot System (No Lock)4.1 Observe and inspect the carbide inserts fordamage. The outboard tip should be about 1/8-inchahead of the inboard or hat side of the rotor.AMMCO 800 On-The-Vehicle Brake Lathe • 7
Page 1 and 2: Safety Instructions Pgs. iii-viInst
Page 3 and 4: Owner’s ResponsibilityTo maintain
Page 5 and 6: Safety Notices and DecalsFor your s
Page 7 and 8: On-The-VehicleBefore You BeginThe A
Page 9 and 10: On-The-VehicleStandard AccessoriesP
Page 11: On-The-Vehicle800 On-The-Vehicle Br
Page 15 and 16: On-The-Vehicle5.4 Now practice usin
Page 17 and 18: On-The-VehicleOperating Instruction
Page 19 and 20: On-The-VehicleLathe to Vehicle Atta
Page 21 and 22: On-The-VehicleAdjusting the Lathe R
Page 23 and 24: On-The-VehicleThe mirror maybe used
Page 25 and 26: On-The-Vehicle13.5 Inspect the roto
Page 27 and 28: On-The-VehicleAdjustment KnobReposi

On-The-Vehicle - aesco

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?