NetPoint Configuration Guide

More documents

Recommendations

Info

2. An Ethernet RJ45 cable of suitable length.3. Ethernet switch or router is required to connect more than one thin client or other network devices.Additional Ethernet cables will be required in this case.1.2 Recommended Server <strong>Configuration</strong>Given below is the recommended minimum Host PC/Server configuration for connecting up thecorresponding number of thin clients.1.3 ConnectingTC-V150 FrontTC-V150 Back3
TC-604L FrontTC-604L BackSTEP 1. Connect your Keyboard/Mouse/Monitor/Speaker or Headphone as shown in the picture:STEP 2. Connect the thin client to Host PC/Switch/Router using the Ethernet cable with RJ45 pins asshown below.CAUTIONUSE ONLY THE ORIGINAL POWERSUPPLY ADAPTERSTEP 3. Connect the power adapter.4
Page 1 and 2: NetPointConfiguration Guidefor thin
Page 3: 1. IntroductionXtendLan thin client
Page 7 and 8: 4. Find the location where you put
Page 9 and 10: Choose “I accept the terms of the
Page 11 and 12: If it is 64bit Windows and “USB p
Page 13 and 14: Click on “Yes”:This time, choos
Page 15 and 16: Then continue with the installation
Page 17 and 18: Click on “Create Account”. Now
Page 19 and 20: Double click on “1”, or right c
Page 21 and 22: A list of user groups will show up.
Page 23 and 24: In the new window, click on Remote,
Page 25 and 26: In the pop up window, choose “OK
Page 27 and 28: USE STATIC IP ADDRESS FOR THE THIN
Page 29 and 30: After setup thin client’s Local I
Page 31 and 32: 4. Thin client Configuration4.1 Set
Page 33 and 34: Note:When logon to host PC, you can
Page 35 and 36: 4.5 Setting up thin client through
Page 37 and 38: 5.2.2 NameFor management purposes,
Page 39 and 40: 5.2.4 View user’s desktopIn the N
Page 41 and 42: “Net Ser” is where you can chan
Page 43 and 44: 5.2.7 Configure the thin client ---
Page 45 and 46: 6. Configuration Local Printer1. Th
Page 47 and 48: 7.1 Windows 7 64bit Audio Redirecti
Page 49 and 50: Click on “Allow audio and video p
Page 51 and 52: 7.2 Windows 2008R2 64bit Audio Redi
Page 53 and 54: Click on “Client Experience”, c
Page 55 and 56:
Click on “Client Settings”:Unch
Page 57 and 58:
8. Configuration with Linux OS8.1 U
Page 59 and 60:
6. sudo apt-get install tightvncser
Page 61 and 62:
C. Configuration file Follow these
Page 63 and 64:
xrdp autostart settingNOTE: The hos
Page 65 and 66:
5. reboot the system, logon with
Page 67 and 68:
8.2 Installation of RDP Server in R
Page 69 and 70:
10. Enable remote log in68
Page 71 and 72:
8.3 Installation of RDP Server in C
Page 73 and 74:
12. Enable remote log in72
Page 75 and 76:
9. FAQ1.Q: How to set user account
show all

NetPoint Configuration Guide

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?