35401.1 PKZ Archer RTF BNF manual.indb - Robot MarketPlace

ENArming the ESC and ReceiverArming the ESC also occurs after binding as previously described, butsubsequent connection of a fl ight battery requires the steps below.1CAUTION: Always keep hands away from the propeller. When armed,the motor will turn the propeller in response to any throttle movement.CAUTION: Always disconnect the Li-Po battery from the aircraft receiverwhen not fl ying to avoid over-discharging the battery. Batteries discharged to avoltage lower than the lowest approved voltage may become damaged,resulting in loss of performance and potential fi re when batteries are charged.1. Power ON the transmitter and lower the throttle and throttle trim to theirlowest settings.2DO NOT connect the battery while the throttle stick is at full or the ESC will gointo programming mode. If a musical tone sounds after 5 seconds, immediatelydisconnect the battery, then lower the throttle.2. Remove the canopy and install the fully charged battery in the batterycompartment using the hook and loop strip, then connect the battery tothe ESC.3. When power is applied to the ESC:1) The ESC will sound two tones to indicate that LVC is properly set.2) An LED will light on the receiver.38