MOUNTED UNIT - Bargam UK

Mounted unitBooklet 4BMixing with pump and mixer in the cover1 - Insert water into the tank until 1/2 ÷2/3 of the maximum level isreached (see “Tank filling”).2 - Add the antifoaming additive (ifrequired).3 - Enable the pump and turn valve(B) to activate the mixer in thecover (see figure).4 - Insert the chemical into the tankaccording to the instructions.5 - Insert water into the tank until themaximum level is reached (see“Tank filling”).6 - Once the operation is completedclose valve (B).E_011.tifMixing with control unit and mixer in the cover1 - Insert water into the tank until 1/2 ÷2/3 of the maximum level isreached (see “Tank filling”).2 - Add the antifoaming additive (ifrequired).3 - Enable the control unit (see booklet6) and close all boom sectionsto activate the mixer in the cover(see figure).4 - Insert the chemical into the tankaccording to the instructions.5 - Insert water into the tank until themaximum level is reached (see“Tank filling”).6 - Once the operation is completeddisengage the mixer.E_012.tifMixing with Mixer (600 Lt)To mix the product, follow the procedure below:1 - Make sure that the system is clean and pour thenecessary water for the treatment into the maintank (see page 11 "Water filling through tank fillinghose").If a sufficient water quantity is present in the maintank, pass to the next phases.2 - Turn the levers of cocks (D) and (E - F - G) asshown in the picture.3 - Activate the pump.4 - Carry out the operations for the preparation andmixing of the chemical (see leaflet 5).233.011English- 14 -user manual