Draka Industrial Cable GmbH - Prysmian Group

More documents

Recommendations

Info

MOUNTING INSTRUCTIONS MA 001E-2004At a distance of around 15mm from the cable stripping edge, the FO bundle has tobe thickened up to ca. 12mm diameter by means of sticky tape (Photo 2). Treat thecorrugated tube in the same manner about 35mm from the said edge (Photo 3), with17mm target thickness (= Inner dia of entrance element).These thickened sections shall build a plug for the resin injected later on.Photo 2 Photo 3Slide the corrugated tube over the said structure in such a way that the thickenedpart of the bundle acts as a stopper within the corrugated tube (Photo 4). Finalposition of the plug around 5-8mm within the corrugated tube (fixed by means ofresin).Photo 4 Photo 5After that, the entry sleeve has to shifted over the thickened area, then fastened to itand sealed with sticky tape ( Photo 5).Page 4/10Author: W. Moritz Draka Industrial Cable GmbH Issued: Nov. 2004
MOUNTING INSTRUCTIONS MA 001E-2004Now you have to fasten the assembly in a vertical position and pour it with CellpackEG cast resin up to the brim of the entry sleeve (Photo 6).Photo 6 Photo 7When the resin is cured, incise and remove the FO tubes ca. 5mm from the resinsurface. The loose tube fibres are freely accessible now (Photo 7).Put each 1 spacer in the jointing sleeves (Photo 8).Photo 8Page 5/10Author: W. Moritz Draka Industrial Cable GmbH Issued: Nov. 2004
Page 6 and 7: MOUNTING INSTRUCTIONS MA 001E-2004S
Page 8 and 9: MOUNTING INSTRUCTIONS MA 001E-2004I
Page 10 and 11: MOUNTING INSTRUCTIONS MA 001E-2004U

Draka Industrial Cable GmbH - Prysmian Group

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?