PROFILE 3 (SLW & ULTIMATE).pdf - Emenite Limited

Recommendations

Info

1.4 END LAPS1.4These are the minimum recommended lapping of sheets along their lengths. Sheets are joined by nailingto the purlins through the end laps.fg. 1.3Recommended end lap for 15° sloper and above150mm50mm75mm825 for 1800 length sheets750 for 2400 length sheets1.4.1 Selection of the End Laps for Different Slopes1.4.1Due to the likelihood of back flow resulting from wind–driven rain and the capillary action of water, it islogical to increase end laps as roof slope decreases.fg. 1.4Capillarity150mm30mm90° 45° 15°®<strong>PROFILE</strong> 3 MANUAL09
Below are the recommended standards for different slopesTable 1.3Degree of slopeRELATIONSHIP BETWEEN SLOPES AND ENDLAPSSLOPEEND LAP% Slope10º 18 300mm11º 20 200mm14º 25 200mm15º and above 27 150mm10®<strong>PROFILE</strong> 3 MANUAL
Page 1 and 2: PROFILE 3TECHNICALMANUAL
Page 3: IndexEmenite ® presentation 4Etex
Page 6 and 7: ®PROFILE 3 MANUAL05
Page 9: • ULTIMATE ® sheets come in stan
Page 13 and 14: 2.22.2 TWO PIECE CORRUGAT ED RIDGEf
Page 15 and 16: 2.62.6 ONE PIECE FLAT WING HIP RIDG
Page 17 and 18: fig. 3.1Recommended purlin spacings
Page 19 and 20: 3.23.2 FASTENERSFasteners are respo
Page 21 and 22: 44. DESIGN INFORMATION4.14.1 PARTS
Page 23 and 24: advisable to avoid backflow through
Page 25 and 26: These values are valid, only if the
Page 27 and 28: 55. INSTALLATION5.15.1 RECOMMENDED
Page 29 and 30: fig. 5.3Defining the left and the r
Page 31 and 32: 5.75.7 FASTENING PROCEDUREPROFILE 3
Page 33 and 34: 66. ESTIMATION OF MATERIALS6.16.1 E
Page 35 and 36: SOLUTION FOR SUPERLIGHTWEIGHT®NR =
Page 37 and 38: 6.26.2 ESTIMATION OF ACCESSORIESTo
Page 39 and 40: 77. TRANSPORTATIO N HANDLINGAND STO
Page 41 and 42: fig. 7.4Unloading sheets40®PROFILE
Page 43 and 44: 99. CARE AND MAINTENANCEThe followi
Page 45 and 46: oofs when it is wet or windy.• Sh
Page 47: 1111.ENVIRONMENTAL PROTSUSTAINABILI

PROFILE 3 (SLW & ULTIMATE).pdf - Emenite Limited

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?