PROFILE 3 (SLW & ULTIMATE).pdf - Emenite Limited

Recommendations

Info

8. SAFETY ON SITE88.1 PRECAUTIONS WHEN LAYINGPROFILE 3 SHEETS8.1Profle 3 roofing sheets, manufactured by EMENITE ® Limited are of high quality and their strength is abovethat required by the relevant standards. However, the roof structure is not to be walked on indiscriminatelybut only along the purlins and rafters. standing or walking on the roofing sheets or accessories and especiallyon their edges must be avoided. It is strongly advised that boards or panels be used to walk on roofs.throwing of heavy objects onto the roof covering or jumping on to them must be avoided. Before laying,the structural elements should be checked for strength and security.8.2 AVOIDING DUST8.2As much as possible, avoid generating inhalable dust. Use hand or slow running tools which produce onlycoarse dust chips. When it is necessary to use abrasive high speed tools, these should be fitted with dustextraction equipment. Any dust falling from fibercement sheets should be thoroughly wet before removalby sweeping.8.3 ACCIDENT PREVENTION8.3Majority of accidents that occur on site can be prevented by taking the necessary precautions. Specifiersshould take notice of all the forces likely to be exerted on a roof or cladding and specify adequate supportstructures to take care of them. Contractors should always keep to specification and ensure thatthe support structure is correctly prepared before sheeting work starts. They should also ensure that onlyexperienced carpenters are allowed onto the roof. Under no circumstances should anyone walk directlyon the sheets. Planks and ladders should be used instead. Sheet fixers and supervisors should ensure thatthese are correctly positioned and adequately supported. On high pitch roofs, safety belts should be used.roofing work should not be done under wet or strong wind conditions.®PROFILE 3 MANUAL41
99. CARE AND MAINTENANCEThe following recommendations are given to extend the service life of our products and toensure their optimal performance.9.19.1 PAINTING RECOMMENDATIONSColoured versions of these products are available on request.EMENITE applies specifically tested paints to the sheets under properly defined conditions.NOTE: EXCLUSIVE CLAUSEEMENITE ® shall not accept liability for products defect resulting fromthe painting of EMENITE ® products by purchasers of company unpaintedEMENITE ® products supplied in standard grey colours.9.29.2 ROOF REPAIRS AND MAINTENANCEEMENITE ® Limited offers complete roof repairs and maintenance service which includes the following:1.2.3.4.Determination of the ageing of the existing roof structural components for eventual replacement orservicing.Determination of the state of the roof covering for the replacement of damaged sheets/tiles andaccessories.Face–lifting the roof covering by cleaning organic growth with fungicides and treating with appropriatesurface biocides.Recoating of EMENITE ® coloured roofs after the pre–requisite steps have been taken as listed in (1) – (3)above.42®PROFILE 3 MANUAL
Page 1 and 2: PROFILE 3TECHNICALMANUAL
Page 3: IndexEmenite ® presentation 4Etex
Page 6 and 7: ®PROFILE 3 MANUAL05
Page 9 and 10: • ULTIMATE ® sheets come in stan
Page 11 and 12: Below are the recommended standards
Page 13 and 14: 2.22.2 TWO PIECE CORRUGAT ED RIDGEf
Page 15 and 16: 2.62.6 ONE PIECE FLAT WING HIP RIDG
Page 17 and 18: fig. 3.1Recommended purlin spacings
Page 19 and 20: 3.23.2 FASTENERSFasteners are respo
Page 21 and 22: 44. DESIGN INFORMATION4.14.1 PARTS
Page 23 and 24: advisable to avoid backflow through
Page 25 and 26: These values are valid, only if the
Page 27 and 28: 55. INSTALLATION5.15.1 RECOMMENDED
Page 29 and 30: fig. 5.3Defining the left and the r
Page 31 and 32: 5.75.7 FASTENING PROCEDUREPROFILE 3
Page 33 and 34: 66. ESTIMATION OF MATERIALS6.16.1 E
Page 35 and 36: SOLUTION FOR SUPERLIGHTWEIGHT®NR =
Page 37 and 38: 6.26.2 ESTIMATION OF ACCESSORIESTo
Page 39 and 40: 77. TRANSPORTATIO N HANDLINGAND STO
Page 41: fig. 7.4Unloading sheets40®PROFILE
Page 45 and 46: oofs when it is wet or windy.• Sh
Page 47: 1111.ENVIRONMENTAL PROTSUSTAINABILI

PROFILE 3 (SLW & ULTIMATE).pdf - Emenite Limited

Create successful ePaper yourself

Delete template?

Save as template?