PROFILE 3 (SLW & ULTIMATE).pdf - Emenite Limited

5.5 CUTTING5.55.6 MITRING5.6This is the cutting off of the corners of diagonal (inner) sheets that meet at a joint to prevent a thicknessof 4 sheets at that joint. Not all sheets are to be mitred and the number of cuts on a sheet depends on itsposition and sequence of laying. The use of a template makes it easier for marking the cutting line.The sheets and ridges should be cut to avoid having four thicknesses of sheeting in the same plane atthe junctions of sides and end laps as illustrated below in the figure below.fig. 5.6Mitringfig. 5.6MitringSupported sheetGood adjustment of sheetsUnsupported sheetBad adjustment of sheets®PROFILE 3 MANUAL29