JF-Series Operation Manual - BJM Pumps

PUMP OPERATIONThis pump is designed to handle dirty water that contains somesolids. It is not designed to pump volatile or flammable liquids. Do not attempt to pumpany liquids which may damage the pump or endanger personnel as a result of pumpfailure.Do not operate this pump where explosive vapors orflammable material exist. Death or Serious injury will result.TYPICAL MANUAL WATER/WASTEWATER EFFLUENT INSTALLATIONNOTE: Maximum recommended starts should not exceed 10 times per hour.All J-F & JX-F models are provided with a 33” (10m) power cord. NEVERU splice thepower cable due to safety and warranty considerations. Always keep the lead end dry.Note: 208V, 230V, 460V & 575V three phase units do not have a plug and have to beprovided separately.Do not alter the length or repair any power cable with a splice. Thepump motor and cable must be completely waterproof. Damage to the pump orpersonal injury may result from alterations.For manual operation: 208, 230, 460 & 575 volt: Connect directly to the power source orcontrol box. Check the direction of the rotation. Tilt the pump and start it. It should twistin the opposite direction of the arrow (on pump).10