44A ZC - Travis Industries Dealer Services Login Page

OPERATING YOUR APPLIANCELocation and Use of ControlsNOTE:The Combustion Air Control and Combustor By-Pass Control become hotduring operation. Use a glove to adjust these controls while the appliance ishot.Combustion Air ControlThe Combustion Air Control is located in the center over the door and is operated by sliding itfrom left to right. When the control is completely to the left, it is in the fully open position.When it is completely to the right, it is in the fully closed position.Combustor By-Pass ControlThe Combustor By-Pass Control is located on the upper right of the appliance and isoperated by pushing or pulling the control. When pulled out all the way, the catalyticcombustor is bypassed.Blower Speed ControlThe blower system is controlled by a thermostat located under the firebox which turns theblower on automatically as the firebox heats up (approximately 45 minutes from start). Theblower will continue to run as long as the firebox has sufficient heat. Adjust the blower speedby turning the control knob in the lower right corner of the fireplace face (see the illustrationbelow). For low heat range settings operate at the lowest setting and increase the air flow asthe heat range setting is increased by turning the control knob clockwise. The fireplace isequipped with an automatic blower shut off switch to shut off the blower when the doors areopened. The blower will always run as long as the firebox has sufficient heat and the doorsremain closed.Arched FaceSquare FaceCombustionAir ControlCombustorBy-Pass ControlCombustionAir ControlCombustorBy-Pass ControlBlower Speed ControlBlower Speed Control