Hotstart Catalog - Davidson Sales Co.

In-BlockDirect Immersion HeatersNote: In-block heaters are complete with 2-wire w/ground 6foot HPN cord and plug. For cord replacements or “Y”thermocord energy saver, please reference page 56.CUSEngine ModelPart Number120 VoltsPart Number240 Volts Watts Application InformationPerkins – continuedHeat ShieldRequiredOil HeaterThread Size*Product Image700 Series704.30FP531-001 FP532-001 530 Mounts in freeze plug in rear of head800 Series PF531-001 PF532-001 530Mounts in oval shaped plate on the leftfront of the block1004 (right side)FR751-002FR101-000PER-151FPFR752-002FR102-000PER-152FP75010001500Mounts in the 1-1/2” freeze plugopening on the right side of the engine1004 (left side)PER-751FPPER-101FPPER-752FPPER-102FP7501000Mounts in the 1-1/4” freeze plugopening on the left side of the engine1006 (6 Cyl) A & B PER-151FP PER-152FP 1500Mounts in the 1-1/2” freeze plug on theright side of the engine1103C FR531-000 FR532-000 530Replaces 1-1/4” freeze plug on right rearof engine. Element should pointtowards 1 O-clock position.1104 (4 Cyl) CPER-751FPPER-101FPPER-752FPPER-102FP7501000Mounts in 1-1/4” freeze plug opening onright rear of engine with element straightup in 12 O-clock positionVolvoD9 PF151-007 PF152-007 1500Mounts in the oval shaped plate onthe front, right side of the engineD12CPrior to Serial #250502PF151-005 PF152-005 1500Mounts below turbo charger on rightcenter of engineYESD12CAfter Serial #250502PF121-002 PF122-002 1250Mounts below turbo charger on rightcenter of engineYESTD60, TD61, TD70,TD71, TD100,TD101, VE10,TD120, TD121VT6-101 VT6-102 1000Mounts into threaded opening (44mm) inthe front of the engineYanmar3T72HLE4TN82ED4TYYDXL4.41TF401-501 N/A 4001” NPTNo replacement cord availableNOTE: The only replacement parts for the direct immersion heaters is the power cord. Please see the power cord section on page 56 forthe proper replacement cord set.For thermostat control of in-block direct immersion heaters, see page 56. The energy saver Thermocord is available in varioustemperature ranges.Supplemental heat for engines using in-block heaters can be achieved by the installation of oil pan heaters in the lube-oil. Referencepages 26 and 27 of this catalog or consult factory.* If supplemental oil heating is desired, this column gives the correct thread size in oil pan. See NOTE on page 54.52 Customer Support: (509) 536-8660 www.hotstart.com