Omron NT600S Manual - Northern Industrial

Description of Parts and Settings Section 2-12-1-2 DIP Switch SettingsSet the NT600S operation status with the DIP switches located in the bottom rightcorner on the rear side of the body.Switch #SW2-1SW2-2SW2-3SW2-4 toSW2-7SW2-8FunctionScreen data forced initialize effective/ineffectiveON The NT600S will start in a special RUN mode in which thescreen data memory is initialized. When it is started, thememory initialization menu will be displayed. For the initializationprocedure, refer to Section 3-4 Initializing Memory (page 72).[OFF] The NT600S will start in normal RUN mode.Screen display language mode[ON] Messages are displayed in English.OFF Always set at ON.Switching to the System Menu enabled/disabledON The System Menu cannot be displayed. If an error occurs duringa start-up, the System Menu will be automatically displayed.However, “RUN Mode” cannot be entered.[OFF]Not used.ON[OFF]The System Menu can be displayed.This switch must be set to the OFF position.Low battery voltage detection effective/ineffectiveON[OFF]Low battery voltage is detected.Low battery voltage is not detected.[ ] indicates factory setting.ReferenceS In addition to the DIP switches, set also the “Comm. Method”, “Host LinkSpeed”, “Automatic Reset”, etc. at the memory switches. For these settings, referto Section 3-6 “Setting the Conditions of Communications with the PC/Hostby Using the Memory Switches” (page 83)S It may be necessary to change the DIP switch settings after installing theNT600S in an operation panel. Bear this in mind when deciding the installationposition.CautionIf the DIP switch settings have been changed when the NT600S is powered, resetthe power to the NT600S. The changes with the DIP switches become effectiveonly after the power supply is reset.26ηττπ://νιχοντρολσ.χοm